@@ -58,7 +58,7 @@ struct tk_read_base {
* interval.
* @xtime_remainder: Shifted nano seconds left over when rounding
* @cycle_interval
- * @raw_interval: Raw nano seconds accumulated per NTP interval.
+ * @raw_interval: Shifted raw nano seconds accumulated per NTP interval.
* @ntp_error: Difference between accumulated time and NTP time in ntp
* shifted nano seconds.
* @ntp_error_shift: Shift conversion between clock shifted nano seconds and
@@ -100,7 +100,7 @@ struct timekeeper {
u64 cycle_interval;
u64 xtime_interval;
s64 xtime_remainder;
- u32 raw_interval;
+ u64 raw_interval;
/* The ntp_tick_length() value currently being used.
* This cached copy ensures we consistently apply the tick
* length for an entire tick, as ntp_tick_length may change
@@ -262,7 +262,7 @@ static void tk_setup_internals(struct timekeeper *tk, struct clocksource *clock)
/* Go back from cycles -> shifted ns */
tk->xtime_interval = interval * clock->mult;
tk->xtime_remainder = ntpinterval - tk->xtime_interval;
- tk->raw_interval = (interval * clock->mult) >> clock->shift;
+ tk->raw_interval = interval * clock->mult;
/* if changing clocks, convert xtime_nsec shift units */
if (old_clock) {
@@ -1976,7 +1976,7 @@ static u64 logarithmic_accumulation(struct timekeeper *tk, u64 offset,
u32 shift, unsigned int *clock_set)
{
u64 interval = tk->cycle_interval << shift;
- u64 raw_nsecs;
+ u64 nsecps;
/* If the offset is smaller than a shifted interval, do nothing */
if (offset < interval)
@@ -1991,14 +1991,15 @@ static u64 logarithmic_accumulation(struct timekeeper *tk, u64 offset,
*clock_set |= accumulate_nsecs_to_secs(tk);
/* Accumulate raw time */
- raw_nsecs = (u64)tk->raw_interval << shift;
- raw_nsecs += tk->raw_time.tv_nsec;
- if (raw_nsecs >= NSEC_PER_SEC) {
- u64 raw_secs = raw_nsecs;
- raw_nsecs = do_div(raw_secs, NSEC_PER_SEC);
- tk->raw_time.tv_sec += raw_secs;
+ tk->tkr_raw.xtime_nsec += tk->raw_time.tv_nsec << tk->tkr_raw.shift;
+ tk->tkr_raw.xtime_nsec += tk->raw_interval << shift;
+ nsecps = (u64)NSEC_PER_SEC << tk->tkr_raw.shift;
+ while (tk->tkr_raw.xtime_nsec >= nsecps) {
+ tk->tkr_raw.xtime_nsec -= nsecps;
+ tk->raw_time.tv_sec++;
}
- tk->raw_time.tv_nsec = raw_nsecs;
+ tk->raw_time.tv_nsec = tk->tkr_raw.xtime_nsec >> tk->tkr_raw.shift;
+ tk->tkr_raw.xtime_nsec -= tk->raw_time.tv_nsec << tk->tkr_raw.shift;
/* Accumulate error between NTP and clock interval */
tk->ntp_error += tk->ntp_tick << shift;
Due to how the MONOTONIC_RAW accumulation logic was handled, there is the potential for a 1ns discontinuity when we do accumulations. This small discontinuity has for the most part gone un-noticed, but since ARM64 enabled CLOCK_MONOTONIC_RAW in their vDSO clock_gettime implementation, we've seen failures with the inconsistency-check test in kselftest. This patch addresses the issue by using the same sub-ns accumulation handling that CLOCK_MONOTONIC uses, which avoids the issue for in-kernel users. Since the ARM64 vDSO implementation has its own clock_gettime calculation logic, this patch reduces the frequency of errors, but failures are still seen. The ARM64 vDSO will need to be updated to include the sub-nanosecond xtime_nsec values in its calculation for this issue to be completely fixed. Signed-off-by: John Stultz <john.stultz@linaro.org> --- include/linux/timekeeper_internal.h | 4 ++-- kernel/time/timekeeping.c | 19 ++++++++++--------- 2 files changed, 12 insertions(+), 11 deletions(-) -- 2.7.4