| Message ID | 20180608095120.10875-2-tomi.valkeinen@ti.com |
|---|---|
| State | Accepted |
| Commit | eae8291913e5561695e62a7b7b82e97157313ac3 |
| Headers | show |
| Series | [1/2] dra7/am5: remove CEC pin pull-up | expand |
On Fri, Jun 08, 2018 at 12:51:20PM +0300, Tomi Valkeinen wrote: > The pin used for HDMI HPD should be set to GPIO mode on DRA76, similarly > to all the other DRA7 and AM5 SoCs. > > Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com> Applied to u-boot/master, thanks! -- Tom
diff --git a/board/ti/dra7xx/mux_data.h b/board/ti/dra7xx/mux_data.h index 7624152afb..f1f6bd5316 100644 --- a/board/ti/dra7xx/mux_data.h +++ b/board/ti/dra7xx/mux_data.h @@ -858,7 +858,7 @@ const struct pad_conf_entry dra76x_core_padconf_array[] = { {SPI1_D1, (M0 | PIN_INPUT_PULLDOWN)}, /* spi1_d1.spi1_d1 */ {SPI1_D0, (M0 | PIN_INPUT_PULLDOWN)}, /* spi1_d0.spi1_d0 */ {SPI1_CS0, (M0 | PIN_INPUT_PULLUP)}, /* spi1_cs0.spi1_cs0 */ - {SPI1_CS2, (M6 | 0x000f0000)}, /* spi1_cs2.hdmi1_hpd */ + {SPI1_CS2, (M14 | PIN_INPUT_PULLDOWN)}, /* spi1_cs2.gpio7_12 */ {SPI1_CS3, (M6 | PIN_INPUT | SLEWCONTROL)}, /* spi1_cs3.hdmi1_cec */ {SPI2_SCLK, (M1 | PIN_INPUT_PULLDOWN)}, /* spi2_sclk.uart3_rxd */ {SPI2_D1, (M1 | PIN_INPUT_SLEW)}, /* spi2_d1.uart3_txd */
The pin used for HDMI HPD should be set to GPIO mode on DRA76, similarly to all the other DRA7 and AM5 SoCs. Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com> --- board/ti/dra7xx/mux_data.h | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)