diff mbox series

[v4,1/5] mtd: rawnand: denali_dt: set clk_x_rate to 200 MHz unconditionally

Message ID 1529683598-25783-2-git-send-email-yamada.masahiro@socionext.com
State Accepted
Commit 3f6e6986045d47f87bd982910821b7ab9758487e
Headers show
Series mtd: rawnand: denali: add new clocks and improve setup_data_interface | expand

Commit Message

Masahiro Yamada June 22, 2018, 4:06 p.m. UTC
Since commit 1bb88666775e ("mtd: nand: denali: handle timing parameters
by setup_data_interface()"), denali_dt.c gets the clock rate from the
clock driver.  The driver expects the frequency of the bus interface
clock, whereas the clock driver of SOCFPGA provides the core clock.
Thus, the setup_data_interface() hook calculates timing parameters
based on a wrong frequency.

To make it work without relying on the clock driver, hard-code the clock
frequency, 200MHz.  This is fine for existing DT of UniPhier, and also
fixes the issue of SOCFPGA because both platforms use 200 MHz for the
bus interface clock.

Fixes: 1bb88666775e ("mtd: nand: denali: handle timing parameters by setup_data_interface()")
Cc: linux-stable <stable@vger.kernel.org> #4.14+
Reported-by: Philipp Rosenberger <p.rosenberger@linutronix.de>
Suggested-by: Boris Brezillon <boris.brezillon@bootlin.com>
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Tested-by: Richard Weinberger <richard@nod.at>

---

Changes in v4:
  - split into a very simple patch for backport candiate

 drivers/mtd/nand/raw/denali_dt.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

-- 
2.7.4


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
diff mbox series

Patch

diff --git a/drivers/mtd/nand/raw/denali_dt.c b/drivers/mtd/nand/raw/denali_dt.c
index cfd33e6..5869e90 100644
--- a/drivers/mtd/nand/raw/denali_dt.c
+++ b/drivers/mtd/nand/raw/denali_dt.c
@@ -123,7 +123,11 @@  static int denali_dt_probe(struct platform_device *pdev)
 	if (ret)
 		return ret;
 
-	denali->clk_x_rate = clk_get_rate(dt->clk);
+	/*
+	 * Hardcode the clock rate for the backward compatibility.
+	 * This works for both SOCFPGA and UniPhier.
+	 */
+	denali->clk_x_rate = 200000000;
 
 	ret = denali_init(denali);
 	if (ret)