@@ -12,7 +12,10 @@ Required properties:
- interrupts: interrupt specifier for the fifo.
- clocks: phandle to the fifo peripheral clock provided by the audio
clock controller.
-- resets: phandle to memory ARB line provided by the arb reset controller.
+- resets: list of reset phandle, one for each entry reset-names.
+- reset-names: should contain the following:
+ * "arb" : memory ARB line (required)
+ * "rst" : dedicated device reset line (optional)
- #sound-dai-cells: must be 0.
Example of FRDDR A on the A113 SoC:
@@ -13,6 +13,9 @@ Required properties:
* "sysclk" : dsp system clock
- #sound-dai-cells: must be 0.
+Optional property:
+- resets: phandle to the dedicated reset line of the pdm input.
+
Example of PDM on the A113 SoC:
pdm: audio-controller@ff632000 {
@@ -11,6 +11,9 @@ Required properties:
* "refclk" : spdif input reference clock
- #sound-dai-cells: must be 0.
+Optional property:
+- resets: phandle to the dedicated reset line of the spdif input.
+
Example on the A113 SoC:
spdifin: audio-controller@400 {
@@ -10,6 +10,9 @@ Required properties:
* "mclk" : master clock
- #sound-dai-cells: must be 0.
+Optional property:
+- resets: phandle to the dedicated reset line of the spdif output.
+
Example on the A113 SoC:
spdifout: audio-controller@480 {
@@ -6,6 +6,7 @@ Required properties:
- reg: physical base address of the controller and length of memory
mapped region.
- #sound-dai-cells: should be 1.
+- resets: phandle to the dedicated reset line of the hdmitx glue.
Example on the S905X2 SoC:
@@ -13,6 +14,7 @@ tohdmitx: audio-controller@744 {
compatible = "amlogic,g12a-tohdmitx";
reg = <0x0 0x744 0x0 0x4>;
#sound-dai-cells = <1>;
+ resets = <&clkc_audio AUD_RESET_TOHDMITX>;
};
Example of an 'amlogic,axg-sound-card':
The g12a audio subsystem, which is a derivative of the axg subsystem, provides a dedicated reset line for each of the audio components. The axg did not provide that and it is unclear if/when these reset are required. The reset already helped solve a channel mapping issue on the tdm formatter devices. Let's add the reset binding for the other components, so we can describe this in DT. We'll use it later on in the driver when/if needed. Signed-off-by: Jerome Brunet <jbrunet@baylibre.com> --- Documentation/devicetree/bindings/sound/amlogic,axg-fifo.txt | 5 ++++- Documentation/devicetree/bindings/sound/amlogic,axg-pdm.txt | 3 +++ .../devicetree/bindings/sound/amlogic,axg-spdifin.txt | 3 +++ .../devicetree/bindings/sound/amlogic,axg-spdifout.txt | 3 +++ .../devicetree/bindings/sound/amlogic,g12a-tohdmitx.txt | 2 ++ 5 files changed, 15 insertions(+), 1 deletion(-) -- 2.21.0