diff mbox

[06/14] iio: sensors-core: st: Allow full-scale to be an optional feature

Message ID 1378721410-30937-7-git-send-email-lee.jones@linaro.org
State New
Headers show

Commit Message

Lee Jones Sept. 9, 2013, 10:10 a.m. UTC
Some chips either don't support it or fail to provide adequate documentation,
so sometimes it's impossible to enable the feature even if it is supported.

Signed-off-by: Lee Jones <lee.jones@linaro.org>
---
 drivers/iio/common/st_sensors/st_sensors_core.c | 11 +++++++----
 drivers/iio/pressure/st_pressure_core.c         |  6 ++++--
 2 files changed, 11 insertions(+), 6 deletions(-)
diff mbox

Patch

diff --git a/drivers/iio/common/st_sensors/st_sensors_core.c b/drivers/iio/common/st_sensors/st_sensors_core.c
index 965ee22..eb261a5 100644
--- a/drivers/iio/common/st_sensors/st_sensors_core.c
+++ b/drivers/iio/common/st_sensors/st_sensors_core.c
@@ -235,10 +235,13 @@  int st_sensors_init_sensor(struct iio_dev *indio_dev,
 	if (err < 0)
 		goto init_error;
 
-	err = st_sensors_set_fullscale(indio_dev,
-						sdata->current_fullscale->num);
-	if (err < 0)
-		goto init_error;
+	if (sdata->current_fullscale) {
+		err = st_sensors_set_fullscale(indio_dev,
+					       sdata->current_fullscale->num);
+		if (err < 0)
+			goto init_error;
+	} else
+		dev_info(&indio_dev->dev, "Full-scale not possible\n");
 
 	err = st_sensors_set_odr(indio_dev, sdata->odr);
 	if (err < 0)
diff --git a/drivers/iio/pressure/st_pressure_core.c b/drivers/iio/pressure/st_pressure_core.c
index fd7e4d1..506b02d 100644
--- a/drivers/iio/pressure/st_pressure_core.c
+++ b/drivers/iio/pressure/st_pressure_core.c
@@ -247,8 +247,10 @@  int st_press_common_probe(struct iio_dev *indio_dev,
 	indio_dev->channels = pdata->sensor->ch;
 	indio_dev->num_channels = ARRAY_SIZE(st_press_lps331ap_channels);
 
-	pdata->current_fullscale = (struct st_sensor_fullscale_avl *)
-						&pdata->sensor->fs.fs_avl[0];
+	if (pdata->sensor->fs.addr != 0)
+		pdata->current_fullscale = (struct st_sensor_fullscale_avl *)
+			&pdata->sensor->fs.fs_avl[0];
+
 	pdata->odr = pdata->sensor->odr.odr_avl[0].hz;
 
 	if (!plat_data)