diff mbox series

[v2,2/2] dt-bindings: serial: Document CTS/RTS gpios in STM32 UART

Message ID 20200416175729.5550-3-mani@kernel.org
State New
Headers show
Series Add CTS/RTS gpio support to STM32 UART | expand

Commit Message

Manivannan Sadhasivam April 16, 2020, 5:57 p.m. UTC 
From: Manivannan Sadhasivam <mani@kernel.org>

Document the use of CTS/RTS gpios for flow control in STM32 UART
controller. These properties can be used instead of 'st,hw-flow-ctrl'
for making use of any gpio pins for flow control instead of dedicated
pins. It should be noted that both CTS/RTS and 'st,hw-flow-ctrl'
properties cannot co-exist in a design.

Signed-off-by: Manivannan Sadhasivam <mani@kernel.org>
---
 .../devicetree/bindings/serial/st,stm32-uart.yaml  | 14 ++++++++++++++
 1 file changed, 14 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml b/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
index 238c44192d31..75b8521eb7cb 100644
--- a/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
+++ b/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
@@ -48,6 +48,12 @@  properties:
     minItems: 1
     maxItems: 2
 
+  cts-gpios:
+    maxItems: 1
+
+  rts-gpios:
+    maxItems: 1
+
   wakeup-source: true
 
   rs485-rts-delay: true
@@ -55,6 +61,14 @@  properties:
   linux,rs485-enabled-at-boot-time: true
   rs485-rx-during-tx: true
 
+if:
+  required:
+    - st,hw-flow-ctrl
+then:
+  properties:
+    cts-gpios: false
+    rts-gpios: false
+
 required:
   - compatible
   - reg