@@ -1965,6 +1965,8 @@ static void umac_enable_set(struct bcmgenet_priv *priv, u32 mask, bool enable)
u32 reg;
reg = bcmgenet_umac_readl(priv, UMAC_CMD);
+ if (reg & CMD_SW_RESET)
+ return;
if (enable)
reg |= mask;
else
@@ -1984,13 +1986,9 @@ static void reset_umac(struct bcmgenet_priv *priv)
bcmgenet_rbuf_ctrl_set(priv, 0);
udelay(10);
- /* disable MAC while updating its registers */
- bcmgenet_umac_writel(priv, 0, UMAC_CMD);
-
- /* issue soft reset with (rg)mii loopback to ensure a stable rxclk */
- bcmgenet_umac_writel(priv, CMD_SW_RESET | CMD_LCL_LOOP_EN, UMAC_CMD);
+ /* issue soft reset and disable MAC while updating its registers */
+ bcmgenet_umac_writel(priv, CMD_SW_RESET, UMAC_CMD);
udelay(2);
- bcmgenet_umac_writel(priv, 0, UMAC_CMD);
}
static void bcmgenet_intr_disable(struct bcmgenet_priv *priv)
@@ -132,8 +132,12 @@ int bcmgenet_wol_power_down_cfg(struct bcmgenet_priv *priv,
return -EINVAL;
}
- /* disable RX */
+ /* Can't suspend with WoL if MAC is still in reset */
reg = bcmgenet_umac_readl(priv, UMAC_CMD);
+ if (reg & CMD_SW_RESET)
+ reg &= ~CMD_SW_RESET;
+
+ /* disable RX */
reg &= ~CMD_RX_EN;
bcmgenet_umac_writel(priv, reg, UMAC_CMD);
mdelay(10);
@@ -95,6 +95,12 @@ void bcmgenet_mii_setup(struct net_device *dev)
CMD_HD_EN |
CMD_RX_PAUSE_IGNORE | CMD_TX_PAUSE_IGNORE);
reg |= cmd_bits;
+ if (reg & CMD_SW_RESET) {
+ reg &= ~CMD_SW_RESET;
+ bcmgenet_umac_writel(priv, reg, UMAC_CMD);
+ udelay(2);
+ reg |= CMD_TX_EN | CMD_RX_EN;
+ }
bcmgenet_umac_writel(priv, reg, UMAC_CMD);
} else {
/* done if nothing has changed */
As noted in commit 28c2d1a7a0bf ("net: bcmgenet: enable loopback during UniMAC sw_reset") the UniMAC must be clocked at least 5 cycles while the sw_reset is asserted to ensure a clean reset. That commit enabled local loopback to provide an Rx clock from the GENET sourced Tx clk. However, when connected in MII mode the Tx clk is sourced by the PHY so if an EPHY is not supplying clocks (e.g. when the link is down) the UniMAC does not receive the necessary clocks. This commit extends the sw_reset window until the PHY reports that the link is up thereby ensuring that the clocks are being provided to the MAC to produce a clean reset. One consequence is that if the system attempts to enter a Wake on LAN suspend state when the PHY link has not been active the MAC may not have had a chance to initialize cleanly. In this case, we remove the sw_reset and enable the WoL reception path as normal with the hope that the PHY will provide the necessary clocks to drive the WoL blocks if the link becomes active after the system has entered suspend. Fixes: 1c1008c793fa ("net: bcmgenet: add main driver file") Signed-off-by: Doug Berger <opendmb@gmail.com> --- drivers/net/ethernet/broadcom/genet/bcmgenet.c | 10 ++++------ drivers/net/ethernet/broadcom/genet/bcmgenet_wol.c | 6 +++++- drivers/net/ethernet/broadcom/genet/bcmmii.c | 6 ++++++ 3 files changed, 15 insertions(+), 7 deletions(-)