diff mbox series

[1/1] block: ide: use definitions from include/libata.h

Message ID 20200226072028.42619-1-xypron.glpk@gmx.de
State Superseded
Headers show
Series [1/1] block: ide: use definitions from include/libata.h | expand

Commit Message

Heinrich Schuchardt Feb. 26, 2020, 7:20 a.m. UTC
Currently ATA commands are defined both in include/libata.h and
include/ata.h. libata.h is included in ata.h. So this duplication does
not make much sense.

Use the command definitions from include/libata.h where applicable.

Signed-off-by: Heinrich Schuchardt <xypron.glpk at gmx.de>
---
 drivers/block/ide.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

--
2.25.0
diff mbox series

Patch

diff --git a/drivers/block/ide.c b/drivers/block/ide.c
index 4b8a4eac17..67cc4fbc02 100644
--- a/drivers/block/ide.c
+++ b/drivers/block/ide.c
@@ -231,7 +231,7 @@  unsigned char atapi_issue(int device, unsigned char *ccb, int ccblen,
 		 (unsigned char) ((buflen >> 8) & 0xFF));
 	ide_outb(device, ATA_DEV_HD, ATA_LBA | ATA_DEVICE(device));

-	ide_outb(device, ATA_COMMAND, ATAPI_CMD_PACKET);
+	ide_outb(device, ATA_COMMAND, ATA_CMD_PACKET);
 	udelay(50);

 	mask = ATA_STAT_DRQ | ATA_STAT_BUSY | ATA_STAT_ERR;
@@ -570,7 +570,7 @@  static void ide_ident(struct blk_desc *dev_desc)
 			/*
 			 * Start Ident Command
 			 */
-			ide_outb(device, ATA_COMMAND, ATAPI_CMD_IDENT);
+			ide_outb(device, ATA_COMMAND, ATA_CMD_ID_ATAPI);
 			/*
 			 * Wait for completion - ATAPI devices need more time
 			 * to become ready
@@ -582,7 +582,7 @@  static void ide_ident(struct blk_desc *dev_desc)
 			/*
 			 * Start Ident Command
 			 */
-			ide_outb(device, ATA_COMMAND, ATA_CMD_IDENT);
+			ide_outb(device, ATA_COMMAND, ATA_CMD_ID_ATA);

 			/*
 			 * Wait for completion
@@ -966,7 +966,7 @@  ulong ide_read(struct blk_desc *block_dev, lbaint_t blknr, lbaint_t blkcnt,

 	/* first check if the drive is in Powersaving mode, if yes,
 	 * increase the timeout value */
-	ide_outb(device, ATA_COMMAND, ATA_CMD_CHK_PWR);
+	ide_outb(device, ATA_COMMAND, ATA_CMD_CHK_POWER);
 	udelay(50);

 	c = ide_wait(device, IDE_TIME_OUT);	/* can't take over 500 ms */