diff mbox series

[v4,net-next,05/10] net: dsa: felix: perform teardown in reverse order of setup

Message ID 20210111174316.3515736-6-olteanv@gmail.com
State Superseded
Headers show
Series Configuring congestion watermarks on ocelot switch using devlink-sb | expand

Commit Message

Vladimir Oltean Jan. 11, 2021, 5:43 p.m. UTC 
From: Vladimir Oltean <vladimir.oltean@nxp.com>

In general it is desirable that cleanup is the reverse process of setup.
In this case I am not seeing any particular issue, but with the
introduction of devlink-sb for felix, a non-obvious decision had to be
made as to where to put its cleanup method. When there's a convention in
place, that decision becomes obvious.

Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
---
Changes in v4:
Removed the unnecessary if condition.

Changes in v3:
None.

Changes in v2:
None.

 drivers/net/dsa/ocelot/felix.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)
diff mbox series

Patch

diff --git a/drivers/net/dsa/ocelot/felix.c b/drivers/net/dsa/ocelot/felix.c
index 79d0508e5910..83c995360481 100644
--- a/drivers/net/dsa/ocelot/felix.c
+++ b/drivers/net/dsa/ocelot/felix.c
@@ -639,14 +639,14 @@  static void felix_teardown(struct dsa_switch *ds)
 	struct felix *felix = ocelot_to_felix(ocelot);
 	int port;
 
-	if (felix->info->mdio_bus_free)
-		felix->info->mdio_bus_free(ocelot);
+	ocelot_deinit_timestamp(ocelot);
+	ocelot_deinit(ocelot);
 
 	for (port = 0; port < ocelot->num_phys_ports; port++)
 		ocelot_deinit_port(ocelot, port);
-	ocelot_deinit_timestamp(ocelot);
-	/* stop workqueue thread */
-	ocelot_deinit(ocelot);
+
+	if (felix->info->mdio_bus_free)
+		felix->info->mdio_bus_free(ocelot);
 }
 
 static int felix_hwtstamp_get(struct dsa_switch *ds, int port,