@@ -331,6 +331,41 @@ static int pca9685_pwm_apply(struct pwm_chip *chip, struct pwm_device *pwm,
return 0;
}
+static void pca9685_pwm_get_state(struct pwm_chip *chip, struct pwm_device *pwm,
+ struct pwm_state *state)
+{
+ struct pca9685 *pca = to_pca(chip);
+ unsigned long long duty;
+ unsigned int val = 0;
+
+ /* Calculate (chip-wide) period from prescale value */
+ regmap_read(pca->regmap, PCA9685_PRESCALE, &val);
+ /*
+ * PCA9685_OSC_CLOCK_MHZ is 25, i.e. an integer divider of 1000.
+ * The following calculation is therefore only a multiplication
+ * and we are not losing precision.
+ */
+ state->period = (PCA9685_COUNTER_RANGE * 1000 / PCA9685_OSC_CLOCK_MHZ) *
+ (val + 1);
+
+ /* The (per-channel) polarity is fixed */
+ state->polarity = PWM_POLARITY_NORMAL;
+
+ if (pwm->hwpwm >= PCA9685_MAXCHAN) {
+ /*
+ * The "all LEDs" channel does not support HW readout
+ * Return 0 and disabled for backwards compatibility
+ */
+ state->duty_cycle = 0;
+ state->enabled = false;
+ return;
+ }
+
+ state->enabled = true;
+ duty = pca9685_pwm_get_duty(pca, pwm->hwpwm);
+ state->duty_cycle = DIV_ROUND_DOWN_ULL(duty * state->period, PCA9685_COUNTER_RANGE);
+}
+
static int pca9685_pwm_request(struct pwm_chip *chip, struct pwm_device *pwm)
{
struct pca9685 *pca = to_pca(chip);
@@ -353,6 +388,7 @@ static void pca9685_pwm_free(struct pwm_chip *chip, struct pwm_device *pwm)
static const struct pwm_ops pca9685_pwm_ops = {
.apply = pca9685_pwm_apply,
+ .get_state = pca9685_pwm_get_state,
.request = pca9685_pwm_request,
.free = pca9685_pwm_free,
.owner = THIS_MODULE,
Implement .get_state to read-out the current hardware state. The hardware readout may return slightly different values than those that were set in apply due to the limited range of possible prescale and counter register values. Also note that although the datasheet mentions 200 Hz as default frequency when using the internal 25 MHz oscillator, the calculated period from the default prescaler register setting of 30 is 5079040ns. Signed-off-by: Clemens Gruber <clemens.gruber@pqgruber.com> --- Changes since v8: - As we left the math in apply as-is, use DIV_ROUND_DOWN in get_state Changes since v7: - Always return enabled=true for channels except "all LEDs" channel - Use DIV_ROUND_UP in .get_state Changes since v6: - Added a comment regarding the division (Suggested by Uwe) - Rebased drivers/pwm/pwm-pca9685.c | 36 ++++++++++++++++++++++++++++++++++++ 1 file changed, 36 insertions(+)