@@ -60,6 +60,8 @@ dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-coachz-r3-lte.dtb
dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-homestar-r2.dtb
dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-homestar-r3.dtb
dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-homestar-r4.dtb
+dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-kingoftown-r0.dtb
+dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-kingoftown-r1.dtb
dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-lazor-r0.dtb
dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-lazor-r1.dtb
dtb-$(CONFIG_ARCH_QCOM) += sc7180-trogdor-lazor-r1-kb.dtb
new file mode 100644
@@ -0,0 +1,44 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Google Kingoftown board device tree source
+ *
+ * Copyright 2021 Google LLC.
+ */
+
+/dts-v1/;
+
+#include "sc7180-trogdor.dtsi"
+#include "sc7180-trogdor-ti-sn65dsi86.dtsi"
+#include "sc7180-trogdor-kingoftown.dtsi"
+
+/ {
+ model = "Google Kingoftown (rev0)";
+ compatible = "google,kingoftown-rev0", "qcom,sc7180";
+};
+
+/*
+ * In rev1+, the enable pin of pp3300_fp_tp will be tied to pp1800_l10a
+ * power rail instead, since kingoftown does not have FP.
+ */
+&pp3300_fp_tp {
+ gpio = <&tlmm 74 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&en_fp_rails>;
+};
+
+&tlmm {
+ en_fp_rails: en-fp-rails {
+ pinmux {
+ pins = "gpio74";
+ function = "gpio";
+ };
+
+ pinconf {
+ pins = "gpio74";
+ drive-strength = <2>;
+ bias-disable;
+ };
+ };
+};
new file mode 100644
@@ -0,0 +1,17 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Google Kingoftown board device tree source
+ *
+ * Copyright 2021 Google LLC.
+ */
+
+/dts-v1/;
+
+#include "sc7180-trogdor.dtsi"
+#include "sc7180-trogdor-parade-ps8640.dtsi"
+#include "sc7180-trogdor-kingoftown.dtsi"
+
+/ {
+ model = "Google Kingoftown (rev1+)";
+ compatible = "google,kingoftown", "qcom,sc7180";
+};
new file mode 100644
@@ -0,0 +1,225 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Google Kingoftown board device tree source
+ *
+ * Copyright 2021 Google LLC.
+ */
+
+/* This file must be included after sc7180-trogdor.dtsi */
+
+#include "sc7180-trogdor-lte-sku.dtsi"
+
+&alc5682 {
+ compatible = "realtek,rt5682s";
+ realtek,dmic1-clk-pin = <2>;
+ realtek,dmic-clk-rate-hz = <2048000>;
+};
+
+&ap_tp_i2c {
+ status = "okay";
+};
+
+ap_ts_pen_1v8: &i2c4 {
+ status = "okay";
+ clock-frequency = <400000>;
+
+ ap_ts: touchscreen@10 {
+ compatible = "elan,ekth3500";
+ reg = <0x10>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&ts_int_l>, <&ts_reset_l>;
+
+ interrupt-parent = <&tlmm>;
+ interrupts = <9 IRQ_TYPE_LEVEL_LOW>;
+
+ vcc33-supply = <&pp3300_ts>;
+
+ reset-gpios = <&tlmm 8 GPIO_ACTIVE_LOW>;
+ };
+};
+
+&keyboard_controller {
+ function-row-physmap = <
+ MATRIX_KEY(0x00, 0x02, 0) /* T1 */
+ MATRIX_KEY(0x03, 0x02, 0) /* T2 */
+ MATRIX_KEY(0x02, 0x02, 0) /* T3 */
+ MATRIX_KEY(0x01, 0x02, 0) /* T4 */
+ MATRIX_KEY(0x03, 0x04, 0) /* T5 */
+ MATRIX_KEY(0x02, 0x04, 0) /* T6 */
+ MATRIX_KEY(0x01, 0x04, 0) /* T7 */
+ MATRIX_KEY(0x02, 0x09, 0) /* T8 */
+ MATRIX_KEY(0x01, 0x09, 0) /* T9 */
+ MATRIX_KEY(0x00, 0x04, 0) /* T10 */
+ >;
+ linux,keymap = <
+ MATRIX_KEY(0x00, 0x02, KEY_BACK)
+ MATRIX_KEY(0x03, 0x02, KEY_REFRESH)
+ MATRIX_KEY(0x02, 0x02, KEY_ZOOM)
+ MATRIX_KEY(0x01, 0x02, KEY_SCALE)
+ MATRIX_KEY(0x03, 0x04, KEY_SYSRQ)
+ MATRIX_KEY(0x02, 0x04, KEY_BRIGHTNESSDOWN)
+ MATRIX_KEY(0x01, 0x04, KEY_BRIGHTNESSUP)
+ MATRIX_KEY(0x02, 0x09, KEY_MUTE)
+ MATRIX_KEY(0x01, 0x09, KEY_VOLUMEDOWN)
+ MATRIX_KEY(0x00, 0x04, KEY_VOLUMEUP)
+
+ CROS_STD_MAIN_KEYMAP
+ >;
+};
+
+&panel {
+ compatible = "edp-panel";
+};
+
+&pp3300_dx_edp {
+ gpio = <&tlmm 67 GPIO_ACTIVE_HIGH>;
+};
+
+&sound {
+ compatible = "google,sc7180-trogdor";
+ model = "sc7180-rt5682s-max98357a-1mic";
+};
+
+&wifi {
+ qcom,ath10k-calibration-variant = "GO_KINGOFTOWN";
+};
+
+/* PINCTRL - modifications to sc7180-trogdor.dtsi */
+
+&en_pp3300_dx_edp {
+ pinmux {
+ pins = "gpio67";
+ };
+
+ pinconf {
+ pins = "gpio67";
+ };
+};
+
+/* PINCTRL - board-specific pinctrl */
+
+&tlmm {
+ gpio-line-names = "TP_INT_L", /* 0 */
+ "AP_RAM_ID0",
+ "AP_SKU_ID2",
+ "AP_RAM_ID1",
+ "",
+ "AP_RAM_ID2",
+ "AP_TP_I2C_SDA",
+ "AP_TP_I2C_SCL",
+ "TS_RESET_L",
+ "TS_INT_L",
+ "", /* 10 */
+ "EDP_BRIJ_IRQ",
+ "AP_EDP_BKLTEN",
+ "",
+ "",
+ "EDP_BRIJ_I2C_SDA",
+ "EDP_BRIJ_I2C_SCL",
+ "HUB_RST_L",
+ "",
+ "",
+ "", /* 20 */
+ "",
+ "",
+ "AMP_EN",
+ "",
+ "",
+ "",
+ "",
+ "HP_IRQ",
+ "",
+ "", /* 30 */
+ "AP_BRD_ID2",
+ "BRIJ_SUSPEND",
+ "AP_BRD_ID0",
+ "AP_H1_SPI_MISO",
+ "AP_H1_SPI_MOSI",
+ "AP_H1_SPI_CLK",
+ "AP_H1_SPI_CS_L",
+ "BT_UART_CTS",
+ "BT_UART_RTS",
+ "BT_UART_TXD", /* 40 */
+ "BT_UART_RXD",
+ "H1_AP_INT_ODL",
+ "",
+ "UART_AP_TX_DBG_RX",
+ "UART_DBG_TX_AP_RX",
+ "HP_I2C_SDA",
+ "HP_I2C_SCL",
+ "FORCED_USB_BOOT",
+ "AMP_BCLK",
+ "AMP_LRCLK", /* 50 */
+ "AMP_DIN",
+ "",
+ "HP_BCLK",
+ "HP_LRCLK",
+ "HP_DOUT",
+ "HP_DIN",
+ "HP_MCLK",
+ "AP_SKU_ID0",
+ "AP_EC_SPI_MISO",
+ "AP_EC_SPI_MOSI", /* 60 */
+ "AP_EC_SPI_CLK",
+ "AP_EC_SPI_CS_L",
+ "AP_SPI_CLK",
+ "AP_SPI_MOSI",
+ "AP_SPI_MISO",
+ /*
+ * AP_FLASH_WP_L is crossystem ABI. Schematics
+ * call it BIOS_FLASH_WP_L.
+ */
+ "AP_FLASH_WP_L",
+ "EN_PP3300_DX_EDP",
+ "AP_SPI_CS0_L",
+ "",
+ "", /* 70 */
+ "",
+ "",
+ "",
+ "EN_FP_RAILS",
+ "UIM2_DATA",
+ "UIM2_CLK",
+ "UIM2_RST",
+ "UIM2_PRESENT_L",
+ "UIM1_DATA",
+ "UIM1_CLK", /* 80 */
+ "UIM1_RST",
+ "",
+ "CODEC_PWR_EN",
+ "HUB_EN",
+ "",
+ "",
+ "",
+ "",
+ "",
+ "AP_SKU_ID1", /* 90 */
+ "AP_RST_REQ",
+ "",
+ "AP_BRD_ID1",
+ "AP_EC_INT_L",
+ "",
+ "",
+ "",
+ "",
+ "",
+ "", /* 100 */
+ "",
+ "",
+ "",
+ "EDP_BRIJ_EN",
+ "",
+ "",
+ "",
+ "",
+ "",
+ "", /* 110 */
+ "",
+ "",
+ "",
+ "",
+ "AP_TS_PEN_I2C_SDA",
+ "AP_TS_PEN_I2C_SCL",
+ "DP_HOT_PLUG_DET",
+ "EC_IN_RW_ODL";
+};
Kingoftown is a trogdor-based board. These dts files are unchanged copies from the downstream Chrome OS 5.4 kernel. Signed-off-by: Joseph S. Barrera III <joebar@chromium.org> --- (no changes since v11) Changes in v11: - Add 'include sc7180-trogdor.dtsi' to sc7180-trogdor-kingoftown-* files. Changes in v10: - Remove 'include sc7180.dtsi' from *all* sc7180-trogdor-kingoftown* files. Changes in v9: - Simplify trackpad enabling (51d30402be75). Changes in v7: - Simplify spi0/spi6 labeling (d277cab7afc7). - Remove #include of <arm/cros-ec-keyboard.dtsi>. Changes in v6: - Add #include of <arm/cros-ec-keyboard.dtsi> from v5.4. Changes in v4: - Fix description (no downstream bits removed). - Add missing version history. Changes in v2: - First inclusion in series. arch/arm64/boot/dts/qcom/Makefile | 2 + .../dts/qcom/sc7180-trogdor-kingoftown-r0.dts | 44 ++++ .../dts/qcom/sc7180-trogdor-kingoftown-r1.dts | 17 ++ .../dts/qcom/sc7180-trogdor-kingoftown.dtsi | 225 ++++++++++++++++++ 4 files changed, 288 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/sc7180-trogdor-kingoftown-r0.dts create mode 100644 arch/arm64/boot/dts/qcom/sc7180-trogdor-kingoftown-r1.dts create mode 100644 arch/arm64/boot/dts/qcom/sc7180-trogdor-kingoftown.dtsi