@@ -676,7 +676,8 @@ static int pvt_set_temp_coeff(struct device *dev, struct pvt_device *pvt)
{
struct temp_coeff *ts_coeff = &pvt->ts_coeff;
const struct device_node *np = dev->of_node;
- u32 series;
+ u32 series, coeff_h, coeff_g, coeff_cal5;
+ s32 coeff_j;
int ret;
/* Incase ts-series property is not defined, use default 5. */
@@ -702,6 +703,32 @@ static int pvt_set_temp_coeff(struct device *dev, struct pvt_device *pvt)
dev_dbg(dev, "temperature sensor series = %u\n", series);
+ /* Override ts-coeff-h/g/j/cal5 if they are defined. */
+ ret = of_property_read_u32(np, "moortec,ts-coeff-h", &coeff_h);
+ if (!ret)
+ ts_coeff->h = coeff_h;
+
+ ret = of_property_read_u32(np, "moortec,ts-coeff-g", &coeff_g);
+ if (!ret)
+ ts_coeff->g = coeff_g;
+
+ ret = of_property_read_s32(np, "moortec,ts-coeff-j", &coeff_j);
+ if (!ret)
+ ts_coeff->j = coeff_j;
+
+ ret = of_property_read_u32(np, "moortec,ts-coeff-cal5", &coeff_cal5);
+ if (!ret) {
+ if (coeff_cal5 == 0) {
+ dev_err(dev, "moortec,ts-coeff-cal5 can't be 0\n");
+ return -EINVAL;
+ }
+
+ ts_coeff->cal5 = coeff_cal5;
+ }
+
+ dev_dbg(dev, "ts-coeff: h = %u, g = %u, j = %d, cal5 = %u\n",
+ ts_coeff->h, ts_coeff->g, ts_coeff->j, ts_coeff->cal5);
+
return 0;
}
Use thermal coefficients from the device tree if they exist. Otherwise, use default values according to the series (5 or 6). All coefficients can be used or only part of them. The coefficients shall be used for fine tuning the default values since coefficients can vary between product and product. Signed-off-by: Eliav Farber <farbere@amazon.com> --- drivers/hwmon/mr75203.c | 29 ++++++++++++++++++++++++++++- 1 file changed, 28 insertions(+), 1 deletion(-)