| Message ID | 20230503-topic-sm8450-upstream-reboot-reason-v1-2-c5ac3dd5b49f@linaro.org |
|---|---|
| State | Superseded |
| Headers | show |
| Series | arm64: dts: qcom: pmk[345]50: enable reboot reason | expand |
On 03/05/2023 16:13, Neil Armstrong wrote: > Introduce sdam_2 node, which is to be used via nvmem for power on > reasons during reboot. Add supported PoN reasons supported via sdam_2 > node. > > Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org> > --- > arch/arm64/boot/dts/qcom/pmk8550.dtsi | 23 +++++++++++++++++++++++ > 1 file changed, 23 insertions(+) Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> Tested-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> Tested on QRD8550 Best regards, Krzysztof
diff --git a/arch/arm64/boot/dts/qcom/pmk8550.dtsi b/arch/arm64/boot/dts/qcom/pmk8550.dtsi index 201efeda7d2d..8c897d4fee29 100644 --- a/arch/arm64/boot/dts/qcom/pmk8550.dtsi +++ b/arch/arm64/boot/dts/qcom/pmk8550.dtsi @@ -8,6 +8,16 @@ #include <dt-bindings/interrupt-controller/irq.h> #include <dt-bindings/spmi/spmi.h> +/ { + reboot-mode { + compatible = "nvmem-reboot-mode"; + nvmem-cells = <&reboot_reason>; + nvmem-cell-names = "reboot-mode"; + mode-recovery = <0x01>; + mode-bootloader = <0x02>; + }; +}; + &spmi_bus { pmk8550: pmic@0 { compatible = "qcom,pm8550", "qcom,spmi-pmic"; @@ -42,6 +52,19 @@ pmk8550_rtc: rtc@6100 { status = "disabled"; }; + pmk8550_sdam_2: nvram@7100 { + compatible = "qcom,spmi-sdam"; + reg = <0x7100>; + #address-cells = <1>; + #size-cells = <1>; + ranges = <0 0x7100 0x100>; + + reboot_reason: reboot-reason@48 { + reg = <0x48 0x1>; + bits = <1 7>; + }; + }; + pmk8550_gpios: gpio@8800 { compatible = "qcom,pmk8550-gpio", "qcom,spmi-gpio"; reg = <0xb800>;
Introduce sdam_2 node, which is to be used via nvmem for power on reasons during reboot. Add supported PoN reasons supported via sdam_2 node. Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org> --- arch/arm64/boot/dts/qcom/pmk8550.dtsi | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+)