Message ID | 20240323-resend-hwtimestamp-v10-3-b08e590d97c7@chromium.org |
---|---|
State | Accepted |
Commit | 9183c6f1a21e0da4415762c504e2d7f784304d12 |
Headers | show |
Series | uvcvideo: Fixes for hw timestamping | expand |
On Sat, Mar 23, 2024 at 10:48:04AM +0000, Ricardo Ribalda wrote: > Logitech C922 internal SOF does not increases at a stable rate of 1kHz. > This causes that the device_sof and the host_sof run at different rates, > breaking the clock domain conversion algorithm. Eg: > > 30 (6) [-] none 30 614400 B 21.245557 21.395214 34.133 fps ts mono/SoE > 31 (7) [-] none 31 614400 B 21.275327 21.427246 33.591 fps ts mono/SoE > 32 (0) [-] none 32 614400 B 21.304739 21.459256 34.000 fps ts mono/SoE > 33 (1) [-] none 33 614400 B 21.334324 21.495274 33.801 fps ts mono/SoE > * 34 (2) [-] none 34 614400 B 21.529237 21.527297 5.130 fps ts mono/SoE > * 35 (3) [-] none 35 614400 B 21.649416 21.559306 8.321 fps ts mono/SoE > 36 (4) [-] none 36 614400 B 21.678789 21.595320 34.045 fps ts mono/SoE > ... > 99 (3) [-] none 99 614400 B 23.542226 23.696352 33.541 fps ts mono/SoE > 100 (4) [-] none 100 614400 B 23.571578 23.728404 34.069 fps ts mono/SoE > 101 (5) [-] none 101 614400 B 23.601425 23.760420 33.504 fps ts mono/SoE > * 102 (6) [-] none 102 614400 B 23.798324 23.796428 5.079 fps ts mono/SoE > * 103 (7) [-] none 103 614400 B 23.916271 23.828450 8.478 fps ts mono/SoE > 104 (0) [-] none 104 614400 B 23.945720 23.860479 33.957 fps ts mono/SoE > > Instead of disabling completely the hardware timestamping for such > hardware we take the assumption that the packet handling jitter is > under 2ms and use the host_sof as dev_sof. > > We can think of the UVC hardware clock as a system with a coarse clock > (the SOF) and a fine clock (the PTS). The coarse clock can be replaced > with a clock on the same frequency, if the jitter of such clock is > smaller than its sampling rate. That way we can save some of the > precision of the fine clock. > > To probe this point we have run three experiments on the Logitech C922. > On that experiment we run the camera at 33fps and we analyse the > difference in msec between a frame and its predecessor. If we display > the histogram of that value, a thinner histogram will mean a better > meassurement. The results for: > - original hw timestamp: https://ibb.co/D1HJJ4x > - pure software timestamp: https://ibb.co/QC9MgVK > - modified hw timestamp: https://ibb.co/8s9dBdk > > This bug in the camera firmware has been confirmed by the vendor. > > lsusb -v > > Bus 001 Device 044: ID 046d:085c Logitech, Inc. C922 Pro Stream Webcam > Device Descriptor: > bLength 18 > bDescriptorType 1 > bcdUSB 2.00 > bDeviceClass 239 Miscellaneous Device > bDeviceSubClass 2 > bDeviceProtocol 1 Interface Association > bMaxPacketSize0 64 > idVendor 0x046d Logitech, Inc. > idProduct 0x085c C922 Pro Stream Webcam > bcdDevice 0.16 > iManufacturer 0 > iProduct 2 C922 Pro Stream Webcam > iSerial 1 80B912DF > bNumConfigurations 1 > > Reviewed-by: Sergey Senozhatsky <senozhatsky@chromium.org> > Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com> > Signed-off-by: Ricardo Ribalda <ribalda@chromium.org> > --- > drivers/media/usb/uvc/uvc_driver.c | 9 +++++++++ > drivers/media/usb/uvc/uvc_video.c | 11 +++++++++++ > drivers/media/usb/uvc/uvcvideo.h | 1 + > 3 files changed, 21 insertions(+) > > diff --git a/drivers/media/usb/uvc/uvc_driver.c b/drivers/media/usb/uvc/uvc_driver.c > index bbd90123a4e76..723e6d5680c2e 100644 > --- a/drivers/media/usb/uvc/uvc_driver.c > +++ b/drivers/media/usb/uvc/uvc_driver.c > @@ -2574,6 +2574,15 @@ static const struct usb_device_id uvc_ids[] = { > .bInterfaceSubClass = 1, > .bInterfaceProtocol = 0, > .driver_info = UVC_INFO_QUIRK(UVC_QUIRK_RESTORE_CTRLS_ON_INIT) }, > + /* Logitech HD Pro Webcam C922 */ > + { .match_flags = USB_DEVICE_ID_MATCH_DEVICE > + | USB_DEVICE_ID_MATCH_INT_INFO, > + .idVendor = 0x046d, > + .idProduct = 0x085c, > + .bInterfaceClass = USB_CLASS_VIDEO, > + .bInterfaceSubClass = 1, > + .bInterfaceProtocol = 0, > + .driver_info = UVC_INFO_QUIRK(UVC_QUIRK_INVALID_DEVICE_SOF) }, > /* Chicony CNF7129 (Asus EEE 100HE) */ > { .match_flags = USB_DEVICE_ID_MATCH_DEVICE > | USB_DEVICE_ID_MATCH_INT_INFO, > diff --git a/drivers/media/usb/uvc/uvc_video.c b/drivers/media/usb/uvc/uvc_video.c > index b2e70fcf4eb4c..d6ca383f643e3 100644 > --- a/drivers/media/usb/uvc/uvc_video.c > +++ b/drivers/media/usb/uvc/uvc_video.c > @@ -558,6 +558,17 @@ uvc_video_clock_decode(struct uvc_streaming *stream, struct uvc_buffer *buf, > stream->clock.last_sof = dev_sof; > > host_sof = usb_get_current_frame_number(stream->dev->udev); > + > + /* > + * On some devices, like the Logitech C922, the device SOF does not run > + * at a stable rate of 1kHz. For those devices use the host SOF instead. > + * In the tests performed so far, this improves the timestamp precision. > + * This is probably explained by a small packet handling jitter from the > + * host, but the exact reason hasn't been fully determined. Given that the counter increases at a low frequency (1 kHz), we have a millisecond from when the frame is received to go into uvc_video_clock_decode() and read it, which should be quite realistic in normal conditions. I suspect that under a relatively high interrupt load, with interrupts of higher priority than USB host, we could end up with more jitter, but it should be still better compared to the broken hw timestamp behavior and not worse than sw timestamp, because that would be subjected to many more factors introducing jitter. Reviewed-by: Tomasz Figa <tfiga@chromium.org> Best regards, Tomasz
diff --git a/drivers/media/usb/uvc/uvc_driver.c b/drivers/media/usb/uvc/uvc_driver.c index bbd90123a4e76..723e6d5680c2e 100644 --- a/drivers/media/usb/uvc/uvc_driver.c +++ b/drivers/media/usb/uvc/uvc_driver.c @@ -2574,6 +2574,15 @@ static const struct usb_device_id uvc_ids[] = { .bInterfaceSubClass = 1, .bInterfaceProtocol = 0, .driver_info = UVC_INFO_QUIRK(UVC_QUIRK_RESTORE_CTRLS_ON_INIT) }, + /* Logitech HD Pro Webcam C922 */ + { .match_flags = USB_DEVICE_ID_MATCH_DEVICE + | USB_DEVICE_ID_MATCH_INT_INFO, + .idVendor = 0x046d, + .idProduct = 0x085c, + .bInterfaceClass = USB_CLASS_VIDEO, + .bInterfaceSubClass = 1, + .bInterfaceProtocol = 0, + .driver_info = UVC_INFO_QUIRK(UVC_QUIRK_INVALID_DEVICE_SOF) }, /* Chicony CNF7129 (Asus EEE 100HE) */ { .match_flags = USB_DEVICE_ID_MATCH_DEVICE | USB_DEVICE_ID_MATCH_INT_INFO, diff --git a/drivers/media/usb/uvc/uvc_video.c b/drivers/media/usb/uvc/uvc_video.c index b2e70fcf4eb4c..d6ca383f643e3 100644 --- a/drivers/media/usb/uvc/uvc_video.c +++ b/drivers/media/usb/uvc/uvc_video.c @@ -558,6 +558,17 @@ uvc_video_clock_decode(struct uvc_streaming *stream, struct uvc_buffer *buf, stream->clock.last_sof = dev_sof; host_sof = usb_get_current_frame_number(stream->dev->udev); + + /* + * On some devices, like the Logitech C922, the device SOF does not run + * at a stable rate of 1kHz. For those devices use the host SOF instead. + * In the tests performed so far, this improves the timestamp precision. + * This is probably explained by a small packet handling jitter from the + * host, but the exact reason hasn't been fully determined. + */ + if (stream->dev->quirks & UVC_QUIRK_INVALID_DEVICE_SOF) + dev_sof = host_sof; + time = uvc_video_get_time(); /* diff --git a/drivers/media/usb/uvc/uvcvideo.h b/drivers/media/usb/uvc/uvcvideo.h index 6fb0a78b1b009..cb9dd50bba8ac 100644 --- a/drivers/media/usb/uvc/uvcvideo.h +++ b/drivers/media/usb/uvc/uvcvideo.h @@ -73,6 +73,7 @@ #define UVC_QUIRK_FORCE_Y8 0x00000800 #define UVC_QUIRK_FORCE_BPP 0x00001000 #define UVC_QUIRK_WAKE_AUTOSUSPEND 0x00002000 +#define UVC_QUIRK_INVALID_DEVICE_SOF 0x00004000 /* Format flags */ #define UVC_FMT_FLAG_COMPRESSED 0x00000001