@@ -161,6 +161,30 @@ static int lp5562_post_init_device(struct lp55xx_chip *chip)
return 0;
}
+static int lp5562_multicolor_brightness(struct lp55xx_led *led)
+{
+ struct lp55xx_chip *chip = led->chip;
+ static const u8 addr[] = {
+ LP5562_REG_R_PWM,
+ LP5562_REG_G_PWM,
+ LP5562_REG_B_PWM,
+ LP5562_REG_W_PWM,
+ };
+ int ret;
+ int i;
+
+ guard(mutex)(&chip->lock);
+ for (i = 0; i < led->mc_cdev.num_colors; i++) {
+ ret = lp55xx_write(chip,
+ addr[led->mc_cdev.subled_info[i].channel],
+ led->mc_cdev.subled_info[i].brightness);
+ if (ret)
+ break;
+ }
+
+ return ret;
+}
+
static int lp5562_led_brightness(struct lp55xx_led *led)
{
struct lp55xx_chip *chip = led->chip;
@@ -364,6 +388,7 @@ static struct lp55xx_device_config lp5562_cfg = {
.post_init_device = lp5562_post_init_device,
.set_led_current = lp5562_set_led_current,
.brightness_fn = lp5562_led_brightness,
+ .multicolor_brightness_fn = lp5562_multicolor_brightness,
.run_engine = lp5562_run_engine,
.firmware_cb = lp55xx_firmware_loaded_cb,
.dev_attr_group = &lp5562_group,
The framework for multicolor brightness control is already in place in the lp55xx-common code but the function to control the multicolor brightness for this particular chip is still missing. Implement the multicolor_brightness_fn function to allow multicolor brightness control of LEDs connected to the LP5562 LED driver. Signed-off-by: Michal Vokáč <michal.vokac@ysoft.com> --- v2: - rebase on top of latest linux v6.12-rc - use guard API instead of mutex lock/unlock This was tested on the imx6dl-yapp43-pegasus board (in tree) that uses this LED driver. There is only an RGB LED on the board so I could not test the white channel. drivers/leds/leds-lp5562.c | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+)