@@ -671,15 +671,14 @@ static int j721e_pcie_resume_noirq(struct device *dev)
return ret;
/*
- * The "Power Sequencing and Reset Signal Timings" table of the
- * PCI Express Card Electromechanical Specification, Revision
- * 5.1, Section 2.9.2, Symbol "T_PERST-CLK", indicates PERST#
- * should be deasserted after minimum of 100us once REFCLK is
- * stable. The REFCLK to the connector in RC mode is selected
- * while enabling the PHY. So deassert PERST# after 100 us.
+ * Section 2.2 of the PCI Express Card Electromechanical
+ * Specification (Revision 5.1) mandates that the deassertion
+ * of the PERST# signal should be delayed by 100 ms (TPVPERL).
+ * This shall ensure that the power and the reference clock
+ * are stable.
*/
if (pcie->reset_gpio) {
- fsleep(PCIE_T_PERST_CLK_US);
+ msleep(PCIE_T_PVPERL_MS);
gpiod_set_value_cansleep(pcie->reset_gpio, 1);
}
According to Section 2.2 of the PCI Express Card Electromechanical Specification (Revision 5.1), in order to ensure that the power and the reference clock are stable, PERST# has to be deasserted after a delay of 100 milliseconds (TPVPERL). Currently, it is being assumed that the power is already stable, which is not necessarily true. Hence, change the delay to PCIE_T_PVPERL_MS to guarantee that power and reference clock are stable. Fixes: f96b69713733 ("PCI: j721e: Use T_PERST_CLK_US macro") Signed-off-by: Siddharth Vadapalli <s-vadapalli@ti.com> --- Hello, This patch is based on commit c2ee9f594da8 KVM: selftests: Fix build on on non-x86 architectures of Mainline Linux. Regards, Siddharth. drivers/pci/controller/cadence/pci-j721e.c | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-)