@@ -5,6 +5,37 @@
#include <dt-bindings/spmi/spmi.h>
+/ {
+ thermal-zones {
+ pm6350-thermal {
+ polling-delay-passive = <100>;
+ polling-delay = <0>;
+
+ thermal-sensors = <&pm6350_temp>;
+
+ trips {
+ trip0 {
+ temperature = <95000>;
+ hysteresis = <0>;
+ type = "passive";
+ };
+
+ trip1 {
+ temperature = <115000>;
+ hysteresis = <0>;
+ type = "hot";
+ };
+
+ trip2 {
+ temperature = <125000>;
+ hysteresis = <0>;
+ type = "critical";
+ };
+ };
+ };
+ };
+};
+
&spmi_bus {
pmic@0 {
compatible = "qcom,pm6350", "qcom,spmi-pmic";
@@ -35,6 +66,13 @@ pm6350_resin: resin {
};
};
+ pm6350_temp: temp-alarm@2400 {
+ compatible = "qcom,spmi-temp-alarm";
+ reg = <0x2400>;
+ interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
+ #thermal-sensor-cells = <0>;
+ };
+
pm6350_gpios: gpios@c000 {
compatible = "qcom,pm6350-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
Add temp-alarm device tree node and a default configuration for the corresponding thermal zone for this PMIC. Temperatures are based on downstream values, except for trip2 where 125°C is used instead of 145°C due to limitations without a configured ADC. Signed-off-by: Luca Weiss <luca.weiss@fairphone.com> --- Changes in v2: * Decrease trip2 temp to 125degC from 145degC after discussion with Matthias arch/arm64/boot/dts/qcom/pm6350.dtsi | 38 ++++++++++++++++++++++++++++ 1 file changed, 38 insertions(+)