@@ -557,7 +557,7 @@ gpi_dma0: dma-controller@800000 {
qupv3_id_0: geniqup@8c0000 {
compatible = "qcom,geni-se-qup";
- reg = <0x0 0x8c0000 0x0 0x2000>;
+ reg = <0x0 0x008c0000 0x0 0x2000>;
clock-names = "m-ahb", "s-ahb";
clocks = <&gcc GCC_QUPV3_WRAP_0_M_AHB_CLK>,
<&gcc GCC_QUPV3_WRAP_0_S_AHB_CLK>;
@@ -630,7 +630,7 @@ gpi_dma1: dma-controller@900000 {
qupv3_id_1: geniqup@9c0000 {
compatible = "qcom,geni-se-qup";
- reg = <0x0 0x9c0000 0x0 0x2000>;
+ reg = <0x0 0x009c0000 0x0 0x2000>;
clock-names = "m-ahb", "s-ahb";
clocks = <&gcc GCC_QUPV3_WRAP_1_M_AHB_CLK>,
<&gcc GCC_QUPV3_WRAP_1_S_AHB_CLK>;
@@ -702,7 +702,7 @@ i2c8: i2c@988000 {
uart9: serial@98c000 {
compatible = "qcom,geni-debug-uart";
- reg = <0 0x98c000 0 0x4000>;
+ reg = <0 0x0098c000 0 0x4000>;
clock-names = "se";
clocks = <&gcc GCC_QUPV3_WRAP1_S3_CLK>;
pinctrl-names = "default";
@@ -1654,11 +1654,11 @@ aoss_qmp: power-controller@c300000 {
spmi_bus: spmi@c440000 {
compatible = "qcom,spmi-pmic-arb";
- reg = <0 0xc440000 0 0x1100>,
- <0 0xc600000 0 0x2000000>,
- <0 0xe600000 0 0x100000>,
- <0 0xe700000 0 0xa0000>,
- <0 0xc40a000 0 0x26000>;
+ reg = <0 0x0c440000 0 0x1100>,
+ <0 0x0c600000 0 0x2000000>,
+ <0 0x0e600000 0 0x100000>,
+ <0 0x0e700000 0 0xa0000>,
+ <0 0x0c40a000 0 0x26000>;
reg-names = "core", "chnls", "obsrvr", "intr", "cnfg";
interrupt-names = "periph_irq";
interrupts-extended = <&pdc 1 IRQ_TYPE_LEVEL_HIGH>;
Some addresses were 7-hex-digits long, or less. Fix that. Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org> --- v1 -> v2: No changes arch/arm64/boot/dts/qcom/sm6350.dtsi | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-)