diff mbox series

[v2,10/21] arm64: dts: qcom: msm8998: Add PCIe bridge node

Message ID 20240321-pcie-qcom-bridge-dts-v2-10-1eb790c53e43@linaro.org
State Accepted
Commit b328bf2595db3bdba87df52ca1a9db431ee99c34
Headers show
Series Add PCIe bridge node in DT for Qcom SoCs | expand

Commit Message

Manivannan Sadhasivam March 21, 2024, 11:16 a.m. UTC 
On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.

Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
 arch/arm64/boot/dts/qcom/msm8998.dtsi | 10 ++++++++++
 1 file changed, 10 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/qcom/msm8998.dtsi b/arch/arm64/boot/dts/qcom/msm8998.dtsi
index 4dfe2d09ac28..d795b2bbe133 100644
--- a/arch/arm64/boot/dts/qcom/msm8998.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8998.dtsi
@@ -972,6 +972,16 @@  pcie0: pcie@1c00000 {
 			power-domains = <&gcc PCIE_0_GDSC>;
 			iommu-map = <0x100 &anoc1_smmu 0x1480 1>;
 			perst-gpios = <&tlmm 35 GPIO_ACTIVE_LOW>;
+
+			pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+			};
 		};
 
 		pcie_phy: phy@1c06000 {