@@ -2,7 +2,7 @@
/*
* Device Tree Source for AM6 SoC Family MCU Domain peripherals
*
- * Copyright (C) 2016-2018 Texas Instruments Incorporated - https://www.ti.com/
+ * Copyright (C) 2016-2020 Texas Instruments Incorporated - https://www.ti.com/
*/
&cbass_mcu {
@@ -268,4 +268,44 @@ mcu_cpsw_cpts_mux: refclk-mux {
};
};
};
+
+ mcu_r5fss0: r5fss@41000000 {
+ compatible = "ti,am654-r5fss";
+ ti,cluster-mode = <1>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0x41000000 0x00 0x41000000 0x20000>,
+ <0x41400000 0x00 0x41400000 0x20000>;
+ power-domains = <&k3_pds 129 TI_SCI_PD_EXCLUSIVE>;
+
+ mcu_r5fss0_core0: r5f@41000000 {
+ compatible = "ti,am654-r5f";
+ reg = <0x41000000 0x00008000>,
+ <0x41010000 0x00008000>;
+ reg-names = "atcm", "btcm";
+ ti,sci = <&dmsc>;
+ ti,sci-dev-id = <159>;
+ ti,sci-proc-ids = <0x01 0xff>;
+ resets = <&k3_reset 159 1>;
+ firmware-name = "am65x-mcu-r5f0_0-fw";
+ ti,atcm-enable = <1>;
+ ti,btcm-enable = <1>;
+ ti,loczrama = <1>;
+ };
+
+ mcu_r5fss0_core1: r5f@41400000 {
+ compatible = "ti,am654-r5f";
+ reg = <0x41400000 0x00008000>,
+ <0x41410000 0x00008000>;
+ reg-names = "atcm", "btcm";
+ ti,sci = <&dmsc>;
+ ti,sci-dev-id = <245>;
+ ti,sci-proc-ids = <0x02 0xff>;
+ resets = <&k3_reset 245 1>;
+ firmware-name = "am65x-mcu-r5f0_1-fw";
+ ti,atcm-enable = <1>;
+ ti,btcm-enable = <1>;
+ ti,loczrama = <1>;
+ };
+ };
};
The AM65x SoCs have a single dual-core Arm Cortex-R5F processor (R5FSS) subsystem/cluster. This R5F cluster (MCU_R5FSS0) is present within the MCU domain, and can be configured at boot time to be either run in a LockStep mode or in an Asymmetric Multi Processing (AMP) fashion in Split-mode. This subsystem has 64 KB each Tightly-Coupled Memory (TCM) internal memories for each core split between two banks - TCMA and TCMB (further interleaved into two banks). There are some IP integration differences from standard Arm R5F clusters such as the absence of an ACP port, presence of an additional TI-specific Region Address Translater (RAT) module for translating 32-bit CPU addresses into larger system bus addresses etc. Add the DT node for this R5F cluster/subsystem, the two R5F cores are added as child nodes to the main cluster node. The cluster is configured to run in LockStep mode by default, with the ATCMs enabled to allow the R5 cores to execute code from DDR with boot-strapping code from ATCM. The inter-processor communication between the main A53 cores and these processors is achieved through shared memory and Mailboxes. The following firmware names are used by default for these cores, and can be overridden in a board dts file if needed: am65x-mcu-r5f0_0-fw (LockStep mode and for Core0 in Split mode) am65x-mcu-r5f0_1-fw (Core1 in Split mode) Signed-off-by: Suman Anna <s-anna@ti.com> --- arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi | 42 ++++++++++++++++++++++++- 1 file changed, 41 insertions(+), 1 deletion(-)