@@ -2,7 +2,7 @@
/*
* Device Tree Source for J721E SoC Family Main Domain peripherals
*
- * Copyright (C) 2016-2019 Texas Instruments Incorporated - https://www.ti.com/
+ * Copyright (C) 2016-2020 Texas Instruments Incorporated - https://www.ti.com/
*/
#include <dt-bindings/phy/phy.h>
#include <dt-bindings/mux/mux.h>
@@ -1581,6 +1581,86 @@ watchdog1: watchdog@2210000 {
assigned-clock-parents = <&k3_clks 253 5>;
};
+ main_r5fss0: r5fss@5c00000 {
+ compatible = "ti,j721e-r5fss";
+ ti,cluster-mode = <1>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0x5c00000 0x00 0x5c00000 0x20000>,
+ <0x5d00000 0x00 0x5d00000 0x20000>;
+ power-domains = <&k3_pds 243 TI_SCI_PD_EXCLUSIVE>;
+
+ main_r5fss0_core0: r5f@5c00000 {
+ compatible = "ti,j721e-r5f";
+ reg = <0x5c00000 0x00008000>,
+ <0x5c10000 0x00008000>;
+ reg-names = "atcm", "btcm";
+ ti,sci = <&dmsc>;
+ ti,sci-dev-id = <245>;
+ ti,sci-proc-ids = <0x06 0xff>;
+ resets = <&k3_reset 245 1>;
+ firmware-name = "j7-main-r5f0_0-fw";
+ ti,atcm-enable = <1>;
+ ti,btcm-enable = <1>;
+ ti,loczrama = <1>;
+ };
+
+ main_r5fss0_core1: r5f@5d00000 {
+ compatible = "ti,j721e-r5f";
+ reg = <0x5d00000 0x00008000>,
+ <0x5d10000 0x00008000>;
+ reg-names = "atcm", "btcm";
+ ti,sci = <&dmsc>;
+ ti,sci-dev-id = <246>;
+ ti,sci-proc-ids = <0x07 0xff>;
+ resets = <&k3_reset 246 1>;
+ firmware-name = "j7-main-r5f0_1-fw";
+ ti,atcm-enable = <1>;
+ ti,btcm-enable = <1>;
+ ti,loczrama = <1>;
+ };
+ };
+
+ main_r5fss1: r5fss@5e00000 {
+ compatible = "ti,j721e-r5fss";
+ ti,cluster-mode = <1>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0x5e00000 0x00 0x5e00000 0x20000>,
+ <0x5f00000 0x00 0x5f00000 0x20000>;
+ power-domains = <&k3_pds 244 TI_SCI_PD_EXCLUSIVE>;
+
+ main_r5fss1_core0: r5f@5e00000 {
+ compatible = "ti,j721e-r5f";
+ reg = <0x5e00000 0x00008000>,
+ <0x5e10000 0x00008000>;
+ reg-names = "atcm", "btcm";
+ ti,sci = <&dmsc>;
+ ti,sci-dev-id = <247>;
+ ti,sci-proc-ids = <0x08 0xff>;
+ resets = <&k3_reset 247 1>;
+ firmware-name = "j7-main-r5f1_0-fw";
+ ti,atcm-enable = <1>;
+ ti,btcm-enable = <1>;
+ ti,loczrama = <1>;
+ };
+
+ main_r5fss1_core1: r5f@5f00000 {
+ compatible = "ti,j721e-r5f";
+ reg = <0x5f00000 0x00008000>,
+ <0x5f10000 0x00008000>;
+ reg-names = "atcm", "btcm";
+ ti,sci = <&dmsc>;
+ ti,sci-dev-id = <248>;
+ ti,sci-proc-ids = <0x09 0xff>;
+ resets = <&k3_reset 248 1>;
+ firmware-name = "j7-main-r5f1_1-fw";
+ ti,atcm-enable = <1>;
+ ti,btcm-enable = <1>;
+ ti,loczrama = <1>;
+ };
+ };
+
c66_0: dsp@4d80800000 {
compatible = "ti,j721e-c66-dsp";
reg = <0x4d 0x80800000 0x00 0x00048000>,
The J721E SoCs have 3 dual-core Arm Cortex-R5F processor (R5FSS) subsystems/clusters. One R5F cluster (MCU_R5FSS0) is present within the MCU domain, and the remaining two clusters are present in the MAIN domain (MAIN_R5FSS0 & MAIN_R5FSS1). Each of these can be configured at boot time to be either run in a LockStep mode or in an Asymmetric Multi Processing (AMP) fashion in Split-mode. These subsystems have 64 KB each Tightly-Coupled Memory (TCM) internal memories for each core split between two banks - ATCM and BTCM (further interleaved into two banks). There are some IP integration differences from standard Arm R5 clusters such as the absence of an ACP port, presence of an additional TI-specific Region Address Translater (RAT) module for translating 32-bit CPU addresses into larger system bus addresses etc. Add the DT nodes for these two MAIN domain R5F cluster/subsystems, the two R5F cores are each added as child nodes to the corresponding main cluster node. Both the clusters are configured to run in LockStep mode by default, with the ATCMs enabled to allow the R5 cores to execute code from DDR with boot-strapping code from ATCM. The inter-processor communication between the main A72 cores and these processors is achieved through shared memory and Mailboxes. The following firmware names are used by default for these cores, and can be overridden in a board dts file if needed: MAIN R5FSS0 Core0: j7-main-r5f0_0-fw (both in LockStep and Split modes) MAIN R5FSS0 Core1: j7-main-r5f0_1-fw (needed only in Split mode) MAIN R5FSS1 Core0: j7-main-r5f1_0-fw (both in LockStep and Split modes) MAIN R5FSS1 Core1: j7-main-r5f1_1-fw (needed only in Split mode) Signed-off-by: Suman Anna <s-anna@ti.com> --- arch/arm64/boot/dts/ti/k3-j721e-main.dtsi | 82 ++++++++++++++++++++++- 1 file changed, 81 insertions(+), 1 deletion(-)