@@ -317,6 +317,7 @@ &xo_board_clk {
&tlmm {
i2c0_default: i2c0-default-state {
+ /* To USB7002T-I/KDXVA0 USB hub (SIP1 only) */
pins = "gpio135", "gpio136";
function = "qup0";
drive-strength = <2>;
@@ -324,6 +325,7 @@ i2c0_default: i2c0-default-state {
};
i2c1_default: i2c1-default-state {
+ /* To PM40028B-F3EI PCIe switch */
pins = "gpio158", "gpio159";
function = "qup1";
drive-strength = <2>;
@@ -331,6 +333,7 @@ i2c1_default: i2c1-default-state {
};
i2c12_default: i2c12-default-state {
+ /* Not connected */
pins = "gpio0", "gpio1";
function = "qup12";
drive-strength = <2>;
@@ -338,6 +341,7 @@ i2c12_default: i2c12-default-state {
};
i2c15_default: i2c15-default-state {
+ /* To display connector (SIP1 only) */
pins = "gpio36", "gpio37";
function = "qup15";
drive-strength = <2>;
@@ -345,6 +349,7 @@ i2c15_default: i2c15-default-state {
};
i2c18_default: i2c18-default-state {
+ /* To ASM330LHH IMU (SIP1 only) */
pins = "gpio66", "gpio67";
function = "qup18";
drive-strength = <2>;
It isn't obvious in the current devicetree what is connected. Go ahead and document what's on the other end. Signed-off-by: Andrew Halaney <ahalaney@redhat.com> --- Not sure if this sort of patch is actually welcomed or not but I went through this exercise (for the prior patch) and thought it might be useful to document. Shazad, this also highlights (unless I misread things) that i2c12 has no use for us, right? If agreed I can remove it but sorting through the lore links that provided all this it seems like at the time it was desired to be added. Thanks, Andrew arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 5 +++++ 1 file changed, 5 insertions(+)