mbox series

[v5,0/2] soundwire: Add support to Qualcomm SoundWire master

Message ID 20191219092842.10885-1-srinivas.kandagatla@linaro.org
Headers show
Series soundwire: Add support to Qualcomm SoundWire master | expand

Message

Srinivas Kandagatla Dec. 19, 2019, 9:28 a.m. UTC 
Thanks for reviewing the v4 patchset.
Here is new patchset addressing all the comments from v3

This patchset adds support for Qualcomm SoundWire Master Controller
found in most of Qualcomm SoCs and WCD audio codecs.

This driver along with WCD934x codec and WSA881x Class-D Smart Speaker
Amplifier drivers is tested on on DragonBoard DB845c based of SDM845
SoC and Lenovo YOGA C630 Laptop based on SDM850.

SoundWire controller on SDM845 is integrated in WCD934x audio codec via
SlimBus interface.

Currently this driver is very minimal and only supports PDM.

Most of the code in this driver is rework of Qualcomm downstream drivers
used in Andriod. Credits to Banajit Goswami and Patrick Lai's Team.

TODO:
	Test and add PCM support.

Thanks,
srini

Changes since v4:
	- moved stream handling to codec as there is a strong hw requirements
	 on port and PA enable sequence on codec side
	- removed dummy runtime pm 
	- cleaned up code as suggested by Pierre


Srinivas Kandagatla (2):
  dt-bindings: soundwire: add bindings for Qcom controller
  soundwire: qcom: add support for SoundWire controller

 .../bindings/soundwire/qcom,sdw.txt           | 167 ++++
 drivers/soundwire/Kconfig                     |   9 +
 drivers/soundwire/Makefile                    |   4 +
 drivers/soundwire/qcom.c                      | 856 ++++++++++++++++++
 4 files changed, 1036 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/soundwire/qcom,sdw.txt
 create mode 100644 drivers/soundwire/qcom.c

-- 
2.21.0