@@ -1530,8 +1530,6 @@ static void w840_remove1(struct pci_dev *pdev)
}
}
-#ifdef CONFIG_PM
-
/*
* suspend/resume synchronization:
* - open, close, do_ioctl:
@@ -1555,9 +1553,9 @@ static void w840_remove1(struct pci_dev *pdev)
* Detach must occur under spin_unlock_irq(), interrupts from a detached
* device would cause an irq storm.
*/
-static int w840_suspend (struct pci_dev *pdev, pm_message_t state)
+static int __maybe_unused w840_suspend(struct device *dev_d)
{
- struct net_device *dev = pci_get_drvdata (pdev);
+ struct net_device *dev = dev_get_drvdata(dev_d);
struct netdev_private *np = netdev_priv(dev);
void __iomem *ioaddr = np->base_addr;
@@ -1590,21 +1588,15 @@ static int w840_suspend (struct pci_dev *pdev, pm_message_t state)
return 0;
}
-static int w840_resume (struct pci_dev *pdev)
+static int __maybe_unused w840_resume(struct device *dev_d)
{
- struct net_device *dev = pci_get_drvdata (pdev);
+ struct net_device *dev = dev_get_drvdata(dev_d);
struct netdev_private *np = netdev_priv(dev);
- int retval = 0;
rtnl_lock();
if (netif_device_present(dev))
goto out; /* device not suspended */
if (netif_running(dev)) {
- if ((retval = pci_enable_device(pdev))) {
- dev_err(&dev->dev,
- "pci_enable_device failed in resume\n");
- goto out;
- }
spin_lock_irq(&np->lock);
iowrite32(1, np->base_addr+PCIBusCfg);
ioread32(np->base_addr+PCIBusCfg);
@@ -1622,19 +1614,17 @@ static int w840_resume (struct pci_dev *pdev)
}
out:
rtnl_unlock();
- return retval;
+ return 0;
}
-#endif
+
+static SIMPLE_DEV_PM_OPS(w840_pm_ops, w840_suspend, w840_resume);
static struct pci_driver w840_driver = {
.name = DRV_NAME,
.id_table = w840_pci_tbl,
.probe = w840_probe1,
.remove = w840_remove1,
-#ifdef CONFIG_PM
- .suspend = w840_suspend,
- .resume = w840_resume,
-#endif
+ .driver.pm = &w840_pm_ops,
};
static int __init w840_init(void)
With stable support of generic PM callbacks, drivers no longer need to use legacy .suspend() and .resume() in which they had to maintain PCI states changes and device's power state themselves. Earlier, .resume() was invoking pci_enable_device(). Drivers should not call PCI legacy helper functions, hence, it was removed. This should not change the behavior of the device as this function is called by PCI core if somehow pm_ops is not able to bind with the driver, else, required tasks are managed by the core itself. Compile-tested only. Signed-off-by: Vaibhav Gupta <vaibhavgupta40@gmail.com> --- drivers/net/ethernet/dec/tulip/winbond-840.c | 26 ++++++-------------- 1 file changed, 8 insertions(+), 18 deletions(-)