From patchwork Fri Jul 3 03:12:30 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Simon Glass X-Patchwork-Id: 240682 List-Id: U-Boot discussion From: sjg at chromium.org (Simon Glass) Date: Thu, 2 Jul 2020 21:12:30 -0600 Subject: [RESEND PATCH v3 19/26] video: pci: Set up the copy framebuffer In-Reply-To: <20200703031237.1546362-1-sjg@chromium.org> References: <20200703031237.1546362-1-sjg@chromium.org> Message-ID: <20200702211204.RESEND.v3.19.I6830e2259b28645c0ed29b68bbadf67598c0ed70@changeid> When using a copy framebuffer we need to tell the video subsystem its address. U-Boot's normally allocated framebuffer is used as the working buffer, but nothing is displayed until it is copied to the copy framebuffer. For this to work the video driver must request that a framebuffer be allocated separately from the hardware framebuffer, so add a check for that. Also add a log category so that logging appears correctly. Signed-off-by: Simon Glass Reviewed-by: Anatolij Gustschin --- (no changes since v1) drivers/pci/pci_rom.c | 22 +++++++++++++++++++++- 1 file changed, 21 insertions(+), 1 deletion(-) diff --git a/drivers/pci/pci_rom.c b/drivers/pci/pci_rom.c index 6a9bc49978..fa29d69e85 100644 --- a/drivers/pci/pci_rom.c +++ b/drivers/pci/pci_rom.c @@ -22,6 +22,8 @@ * Copyright 1997 -- 1999 Martin Mares */ +#define LOG_CATEGORY UCLASS_PCI + #include #include #include @@ -344,7 +346,16 @@ int vbe_setup_video_priv(struct vesa_mode_info *vesa, default: return -EPROTONOSUPPORT; } - plat->base = vesa->phys_base_ptr; + + /* Use double buffering if enabled */ + if (IS_ENABLED(CONFIG_VIDEO_COPY)) { + if (!plat->base) + return log_msg_ret("copy", -ENFILE); + plat->copy_base = vesa->phys_base_ptr; + } else { + plat->base = vesa->phys_base_ptr; + } + log_debug("base = %lx, copy_base = %lx\n", plat->base, plat->copy_base); plat->size = vesa->bytes_per_scanline * vesa->y_resolution; return 0; @@ -372,6 +383,15 @@ int vbe_setup_video(struct udevice *dev, int (*int15_handler)(void)) ret = vbe_setup_video_priv(&mode_info.vesa, uc_priv, plat); if (ret) { + if (ret == -ENFILE) { + /* + * See video-uclass.c for how to set up reserved memory + * in your video driver + */ + log_err("CONFIG_VIDEO_COPY enabled but driver '%s' set up no reserved memory\n", + dev->driver->name); + } + debug("No video mode configured\n"); return ret; }