Patch Metrics

There are 3692 patches submitted by members of this team, and 1247 of those have been accepted upstream.

Patches per month: Submitted Accepted
Time-to-acceptance distribution (in days)

Current Members

Show patches with: State = Action Required       |    Archived = No       |   1684 patches
« 1 2 ... 13 14 15 … 16 17 »
Patch Series S/W/F Date Submitter Delegate State
[32/32] ARM: ux500: Move SDI (MMC) and UART devices under more descriptive heading --- 2013-04-18 Lee Jones New
[30/32] ARM: ux500: Supply MMC DMA configuration via Device Tree --- 2013-04-18 Lee Jones New
[28/32] ARM: ux500: Pass remnant platform data though to DMA40 driver --- 2013-04-18 Lee Jones New
[27/32] ARM: ux500: Stop registering DMA40 from platform data when DT is enabled --- 2013-04-18 Lee Jones New
[26/32] ARM: ux500: Supply UART's DMA configuration via Device Tree --- 2013-04-18 Lee Jones New
[25/32] ARM: ux500: Setup the DMA40 driver's DT node using the new DMA API --- 2013-04-18 Lee Jones New
[24/32] dmaengine: ste_dma40: Supply full Device Tree parsing support --- 2013-04-18 Lee Jones New
[21/32] dmaengine: ste_dma40: Also report the number of logical channels --- 2013-04-18 Lee Jones New
[19/32] dmaengine: ste_dma40: Move more setup into the configuration routines --- 2013-04-18 Lee Jones New
[18/32] dmaengine: ste_dma40: Don't configure runtime configurable setup during allocate --- 2013-04-18 Lee Jones New
[17/32] dmaengine: ste_dma40: Remove redundant argument from d40_phy_cfg() --- 2013-04-18 Lee Jones New
[16/32] dmaengine: ste_dma40: Remove unnecessary call to d40_phy_cfg() --- 2013-04-18 Lee Jones New
[15/32] dmaengine: ste_dma40: Separate Logical Global Interrupt Mask (GIM) unmasking --- 2013-04-18 Lee Jones New
[08/32] dmaengine: ste_dma40: Optimise local MAX() macro --- 2013-04-18 Lee Jones New
[05/32] dmaengine: ste_dma40: Supply macros to resolve 'src' and 'dst' directions --- 2013-04-18 Lee Jones New
[04/32] dmaengine: ste_dma40: Amalgamate DMA source and destination channel numbers --- 2013-04-18 Lee Jones New
[03/32] dmaengine: ste_dma40: Use the BIT macro to replace ugly '(1 << x)'s --- 2013-04-18 Lee Jones New
[v2] serial: pl011: Add Device Tree support to request DMA channels --- 2013-04-18 Lee Jones New
dw_dmac: Couple of small fixups; use of '_' over '-' and a cell-num typo --- 2013-04-17 Lee Jones New
mmc: mmci: Allow MMCI to request channels with information acquired from DT --- 2013-04-17 Lee Jones New
leds: lp5521: add support for Device Tree bindings --- 2013-04-15 Linus Walleij New
ARM: ux500: DT: Rename root node "soc-u9500" into "soc-ux500" --- 2013-04-15 Linus Walleij New
[8/8] ARM: ux500: Amalgamate DMA source and destination channel numbers --- 2013-04-09 Lee Jones New
[7/8] dmaengine: ste_dma40: Use the BIT macro to replace ugly '(1 << x)'s --- 2013-04-09 Lee Jones New
[6/8] dmaengine: ste_dma40: Move LCPA allocation and real-time config --- 2013-04-09 Lee Jones New
[5/8] dmaengine: ste_dma40: Ensure src and dst registers are configured correctly --- 2013-04-09 Lee Jones New
[4/8] dmaengine: ste_dma40: Do not configure channels during an channel allocation --- 2013-04-09 Lee Jones New
[3/8] dmaengine: ste_dma40: Actually write the runtime configuration to registers --- 2013-04-09 Lee Jones New
[5/5] dmaengine: ste_dma40: Move LCPA allocation and real-time config --- 2013-04-08 Lee Jones New
[4/5] dmaengine: ste_dma40: Only configure a channel during a configure request --- 2013-04-08 Lee Jones New
[2/5] dmaengine: ste_dma40: Assign memcpy channels in the driver --- 2013-04-08 Lee Jones New
[1/5] ARM: ux500: Move DMA40 platform data includes file out to include/ --- 2013-04-08 Lee Jones New
[2/2] mfd: db8500-prcmu: Support platform dependant device selection --- 2013-04-04 Lee Jones New
[2/2] mfd: db8500-prcmu: Support platform dependant device selection --- 2013-04-04 Lee Jones New
[9/9] mfd: db8500-prcmu: Support platform dependant device selection --- 2013-04-02 Lee Jones New
[5/9] ARM: ux500: Over-ride TCDM size when booting the DB8540 platform --- 2013-04-02 Lee Jones New
[15/33] regulator: ab8500-ext: Add support for AB9540 regulators --- 2013-03-28 Lee Jones New
[3/3] mfd: db8500-prcmu: Fetch the PRCMU TCPM base address from Device Tree --- 2013-03-25 Lee Jones New
[2/3] mfd: db8500-prcmu: Fetch the PRCMU TCDM base address from Device Tree --- 2013-03-25 Lee Jones New
[1/3] ARM: ux500: Add device nodes for TCDM and TCPM memory locations --- 2013-03-25 Lee Jones New
[5/5] ARM: ux500: Do not supply DMA platform data when booting u8540 platform --- 2013-03-22 Lee Jones New
[3/5] ARM: ux500: Remove platform specific PRCMU and Clk initialisation --- 2013-03-22 Lee Jones New
[2/5] ARM: ux500: Allow the ccu8540 to register its serial devices without pdata --- 2013-03-22 Lee Jones New
[1/5] ARM: ux500: Add machine support for ccu8540 --- 2013-03-22 Lee Jones New
[41/46] regulator: ab8500: Remove the need for a 'delay' property --- 2013-03-21 Lee Jones New
[37/46] regulator: ab8500-ext: Adapt regulator registration for newly changed API --- 2013-03-21 Lee Jones New
[07/46] regulator: ab8500: Add support of low voltage battery --- 2013-03-21 Lee Jones New
gpio: stmpe: pass DT node to irqdomain --- 2013-03-01 Linus Walleij New
[25/35] mfd: ab8500-core: Add additional resources to ab8505_iddet_resources --- 2013-02-15 Lee Jones New
[24/35] mfd: ab8500: Remove unnecessary 'struct device' declaration --- 2013-02-15 Lee Jones New
[16/35] mfd: ab8500: Add more platform checks --- 2013-02-15 Lee Jones New
[11/35] mfd: ab8500-core: Add Interrupt support for ab8540 --- 2013-02-15 Lee Jones New
[10/35] mfd: ab8500-core: Rework MFD sub-device initialisation structures --- 2013-02-15 Lee Jones New
[01/40] mfd: Differentiate between newly added abx500 based platforms --- 2013-02-15 Lee Jones New
[49/49] ARM: ux500: Pass regulator platform data using the new format --- 2013-02-06 Lee Jones New
[47/49] regulator: ab8500: Remove the need for a 'delay' property --- 2013-02-06 Lee Jones New
[46/49] regulator: ab8500: Set enable enable_time in regulator_desc --- 2013-02-06 Lee Jones New
[44/49] regulator: ab8500: Use a struct to select the good regulator configuration --- 2013-02-06 Lee Jones New
[43/49] regulator: ab8500-ext: Adapt regulator registration for newly changed API --- 2013-02-06 Lee Jones New
[42/49] regulator: ab8500: Update vdmic, vamic[1|2] parameters for AB8540 --- 2013-02-06 Lee Jones New
[37/49] regulator: ab8500: Add voltage selection for AUDIO and ANA on AB8505 --- 2013-02-06 Lee Jones New
[35/49] regulator: ab8500: Correct regulator id values --- 2013-02-06 Lee Jones New
[33/49] regulator: ab8500: Use regulator_list_voltage_table() --- 2013-02-06 Lee Jones New
[31/49] regulator: ab8500: Update voltage handling for fixed voltage regulators --- 2013-02-06 Lee Jones New
[30/49] regulator: ab8500: Add support for the ab8540 --- 2013-02-06 Lee Jones New
[28/49] ARM: ux500: regulator: Use device IDs instead of device names --- 2013-02-06 Lee Jones New
[27/49] regulator: ab8500: add support for ab8505 --- 2013-02-06 Lee Jones New
[23/49] regulator: ab8500: Add support for the ab9540 --- 2013-02-06 Lee Jones New
[16/49] ARM: ux500: Add supply for the Proximity and Hal sensor --- 2013-02-06 Lee Jones New
[10/49] regulator: ab8500-ext: Cosmetic changes --- 2013-02-06 Lee Jones New
[08/49] regulator: ab8500: Add support of low voltage battery --- 2013-02-06 Lee Jones New
[73/73] ARM: ux500: Pass regulator platform data using the new format --- 2013-02-04 Lee Jones New
[71/73] regulator: ab8500: Remove the need for a 'delay' property --- 2013-02-04 Lee Jones New
[70/73] regulator: ab8500: Set enable enable_time in regulator_desc --- 2013-02-04 Lee Jones New
[68/73] regulator: ab8500: Provide DT support for additional platforms --- 2013-02-04 Lee Jones New
[67/73] regulator: ab8500: Use a struct to select the good regulator configuration --- 2013-02-04 Lee Jones New
[66/73] regulator: ab8500-ext: Adapt regulator registration for newly changed API --- 2013-02-04 Lee Jones New
[64/73] regulator: ab8500: Update vdmic, vamic[1|2] parameters for AB8540 --- 2013-02-04 Lee Jones New
[54/73] regulator: ab8500: Add voltage selection for AUDIO and ANA on AB8505 --- 2013-02-04 Lee Jones New
[50/73] regulator: ab8500: Correct regulator id values --- 2013-02-04 Lee Jones New
[48/73] regulator: ab8500: Use regulator_list_voltage_table() --- 2013-02-04 Lee Jones New
[45/73] regulator: ab8500: Update voltage handling for fixed voltage regulators --- 2013-02-04 Lee Jones New
[43/73] regulator: ab8500: Add VSDIO definition for the AB8540 --- 2013-02-04 Lee Jones New
[41/73] regulator: ab8500: Provide full settings for AB8540 regulators --- 2013-02-04 Lee Jones New
[40/73] regulator: ab8500: Add AB8505 register initialization --- 2013-02-04 Lee Jones New
[38/73] ARM: ux500: regulator: Use device IDs instead of device names --- 2013-02-04 Lee Jones New
[37/73] regulator: ab8500: add support for ab8505 --- 2013-02-04 Lee Jones New
[33/73] regulator: ab8500: Add support for the AB9540 --- 2013-02-04 Lee Jones New
[25/73] ARM: ux500: Add supply for the Proximity and Hal sensor --- 2013-02-04 Lee Jones New
[21/73] regulator: ab8500-ext: Add VextSupply2 regulator --- 2013-02-04 Lee Jones New
[20/73] regulator: ab8500-ext: Add VextSupply1 regulator --- 2013-02-04 Lee Jones New
[19/73] regulator: ab8500-ext: Add regulator_set_mode/get_mode --- 2013-02-04 Lee Jones New
[14/73] regulator: ab8500: Add support of low voltage battery --- 2013-02-04 Lee Jones New
[12/73] regulator: core: Show consumers that hold a regulator in Sysfs --- 2013-02-04 Lee Jones New
[05/73] ARM: ux500: Vsmps3 controlled by SysClkReq1 --- 2013-02-04 Lee Jones New
[02/73] regulator: ab8500: Initialize Vrf1 regulator --- 2013-02-04 Lee Jones New
[01/73] regulator: ab8500: Remove VBB from suspend force --- 2013-02-04 Lee Jones New
[1/1] ARM: ux500: Enable Snowball's GPIO controlled Ethernet regulator in DT --- 2013-01-21 Lee Jones New
[23/24] ab8500-bm: Fix minor niggles experienced during testing --- 2013-01-21 Lee Jones New
[10/26] mfd: ab8500-debugfs: Wake-up device on debugfs IRQ --- 2013-01-15 Lee Jones New
« 1 2 ... 13 14 15 … 16 17 »