mbox series

[0/2,v2] pwm: add axi-pwm-gen driver

Message ID 20240123220515.279439-1-tgamblin@baylibre.com
Headers show
Series pwm: add axi-pwm-gen driver | expand

Message

Trevor Gamblin Jan. 23, 2024, 10:05 p.m. UTC 
This series adds support for the AXI PWM GEN subsystem found on FPGA IP
cores. It can be used to generate configurable PWM outputs, and includes
options for external synchronization and clock signals.  The work is
being done on behalf of, and therefore lists maintainers from Analog
Devices, Inc.

The series has been tested on actual hardware using an EVAL-AD7985FMCZ
evaluation board. An oscilloscope was used to validate that the
generated PWM signal matched the requested one.

---

v2 changes:
* Address feedback for driver and device tree in v1:
  * Use more reasonable Kconfig approach
  * Use common prefixes for all functions
  * Rename axi_pwmgen struct to axi_pwmgen_ddata
  * Change use of "pwm" to "ddata"
  * Set and check state->polarity
  * Multiply safely with mul_u64_u64_div_u64()
  * Improve handling of max and zero periods
  * Error if clk_rate_hz > NSEC_PER_SEC
  * Add "Limitations" section at top of pwm-axi-pwmgen.c
  * Don't disable outputs by default
  * Remove unnecessary macros for period, duty, offset
  * Fix axi_pwmgen_ddata alignment
  * Don't artificially limit npwm to four
  * Use clk_rate_exclusive_get(), balance with clk_rate_exclusive_put()
  * Cache clk rate in axi_pwmgen_ddata
  * Don't assign pwm->chip.base, do assign pwm->chip.atomic
  * Relocate "unevaluatedProperties" in device tree binding
* Remove redundant calls to clk_get_rate
* Test contents of AXI_PWMGEN_REG_CORE_MAGIC instead of
  arbitrary AXI_PWMGEN_TEST_DATA in AXI_PWMGEN_REG_SCRATCHPAD
* Remove redundant clk struct from axi_pwmgen_ddata
* Add self as module author
* Add major version check for IP core

Link to v1: https://lore.kernel.org/linux-pwm/20240115201222.1423626-1-tgamblin@baylibre.com/

Drew Fustini (2):
  dt-bindings: pwm: Add AXI PWM generator
  pwm: Add driver for AXI PWM generator

 .../bindings/pwm/adi,axi-pwmgen.yaml          |  48 ++++
 MAINTAINERS                                   |   9 +
 drivers/pwm/Kconfig                           |  13 +
 drivers/pwm/Makefile                          |   1 +
 drivers/pwm/pwm-axi-pwmgen.c                  | 246 ++++++++++++++++++
 5 files changed, 317 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/adi,axi-pwmgen.yaml
 create mode 100644 drivers/pwm/pwm-axi-pwmgen.c

Comments

Krzysztof Kozlowski Jan. 24, 2024, 6:40 a.m. UTC | #1 
On 23/01/2024 23:05, Trevor Gamblin wrote:
> From: Drew Fustini <dfustini@baylibre.com>
> 
> Add Analog Devices AXI PWM generator.
> 
> Link: https://wiki.analog.com/resources/fpga/docs/axi_pwm_gen
> Signed-off-by: Drew Fustini <dfustini@baylibre.com>
> Co-developed-by: Trevor Gamblin <tgamblin@baylibre.com>
> Signed-off-by: Trevor Gamblin <tgamblin@baylibre.com>
> 
> ---
> v2 changes:
> * Address feedback for driver and device tree in v1:
>   * Relocate "unevaluatedProperties" in device tree binding
>   * Remove redundant "bindings for" in description
> 

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>

Best regards,
Krzysztof