Message ID | 20240119-rpmh-rsc-fixes-v2-1-e42c0a9e36f0@quicinc.com |
---|---|
State | New |
Headers | show |
Series | [v2] soc: qcom: rpmh-rsc: Enhance check for VREG in-flight request | expand |
On Fri, Jan 19, 2024 at 01:56:54PM +0530, Maulik Shah wrote: > Each RPMh VREG accelerator resource has 3 or 4 contiguous 4-byte aligned > addresses associated with it. These control voltage, enable state, mode, > and in legacy targets, voltage headroom. The current in-flight request > checking logic looks for exact address matches. Requests for different > addresses of the same RPMh resource as thus not detected as in-flight. > > Enhance the in-flight request check for VREG requests by ignoring the > address offset. This ensures that only one request is allowed to be > in-flight for a given VREG resource. This is needed to avoid scenarios > where request commands are carried out by RPMh hardware out-of-order > leading to LDO regulator over-current protection triggering. > > Signed-off-by: Maulik Shah <quic_mkshah@quicinc.com> > Signed-off-by: Elliot Berman <quic_eberman@quicinc.com> The s-o-b chain doesn't look right. > --- > Changes in v2: > - Use GENMASK() and FIELD_GET() > - Link to v1: https://lore.kernel.org/r/20240117-rpmh-rsc-fixes-v1-1-71ee4f8f72a4@quicinc.com > --- > drivers/soc/qcom/rpmh-rsc.c | 21 ++++++++++++++++++++- > 1 file changed, 20 insertions(+), 1 deletion(-) > > diff --git a/drivers/soc/qcom/rpmh-rsc.c b/drivers/soc/qcom/rpmh-rsc.c > index a021dc71807b..e480cde783fe 100644 > --- a/drivers/soc/qcom/rpmh-rsc.c > +++ b/drivers/soc/qcom/rpmh-rsc.c > @@ -1,11 +1,13 @@ > // SPDX-License-Identifier: GPL-2.0 > /* > * Copyright (c) 2016-2018, The Linux Foundation. All rights reserved. > + * Copyright (c) 2023-2024, Qualcomm Innovation Center, Inc. All rights reserved. > */ > > #define pr_fmt(fmt) "%s " fmt, KBUILD_MODNAME > > #include <linux/atomic.h> > +#include <linux/bitfield.h> > #include <linux/cpu_pm.h> > #include <linux/delay.h> > #include <linux/interrupt.h> > @@ -91,6 +93,15 @@ enum { > #define CMD_STATUS_ISSUED BIT(8) > #define CMD_STATUS_COMPL BIT(16) > > +#define ACCL_TYPE(addr) FIELD_GET(GENMASK(19, 16), addr) Command DB is there so we don't have to make assumptions about the addresses of resources. As such, I dislike this define. > +#define VREG_ADDR(addr) FIELD_GET(GENMASK(19, 4), addr) > + > +enum { > + HW_ACCL_CLK = 0x3, > + HW_ACCL_VREG, > + HW_ACCL_BUS, We already define these in the kernel, but with different names: CMD_DB_HW_ARC, CMD_DB_HW_VRM, CMD_DB_HW_BCM. I see no reason to use different names for the same thing. > +}; > + > /* > * Here's a high level overview of how all the registers in RPMH work > * together: > @@ -557,7 +568,15 @@ static int check_for_req_inflight(struct rsc_drv *drv, struct tcs_group *tcs, > for_each_set_bit(j, &curr_enabled, MAX_CMDS_PER_TCS) { > addr = read_tcs_cmd(drv, drv->regs[RSC_DRV_CMD_ADDR], i, j); > for (k = 0; k < msg->num_cmds; k++) { > - if (addr == msg->cmds[k].addr) > + /* > + * Each RPMh VREG accelerator resource has 3 or 4 contiguous 4-byte > + * aligned addresses associated with it. Ignore the offset to check > + * for in-flight VREG requests. > + */ > + if (ACCL_TYPE(msg->cmds[k].addr) == HW_ACCL_VREG && > + VREG_ADDR(msg->cmds[k].addr) == VREG_ADDR(addr)) I'm sure this work, at least for some targets, but I don't fancy encoding this information here. It feels like a hack. Furthermore, I really would like TP_printk() of trace_rpmh_send_msg() to be able to resolve the symbolic names for VRMs as well, and it would need the same information... Please consider how we can query command db for the type and/or grouping information. Regards, Bjorn > + return -EBUSY; > + else if (addr == msg->cmds[k].addr) > return -EBUSY; > } > } > > --- > base-commit: 943b9f0ab2cfbaea148dd6ac279957eb08b96904 > change-id: 20240117-rpmh-rsc-fixes-6c43c7051828 > > Best regards, > -- > Maulik Shah <quic_mkshah@quicinc.com> >
Hi, On 1/28/2024 9:13 AM, Bjorn Andersson wrote: > On Fri, Jan 19, 2024 at 01:56:54PM +0530, Maulik Shah wrote: >> >> Signed-off-by: Maulik Shah <quic_mkshah@quicinc.com> >> Signed-off-by: Elliot Berman <quic_eberman@quicinc.com> > > The s-o-b chain doesn't look right. I will fix in v3. > >> --- >> >> +#define ACCL_TYPE(addr) FIELD_GET(GENMASK(19, 16), addr) > > Command DB is there so we don't have to make assumptions about the > addresses of resources. As such, I dislike this define. sure i will consider querying command db for resource type. > >> +#define VREG_ADDR(addr) FIELD_GET(GENMASK(19, 4), addr) >> + >> +enum { >> + HW_ACCL_CLK = 0x3, >> + HW_ACCL_VREG, >> + HW_ACCL_BUS, > > We already define these in the kernel, but with different names: > CMD_DB_HW_ARC, CMD_DB_HW_VRM, CMD_DB_HW_BCM. I see no reason to use > different names for the same thing. > >> +}; Right, I missed it, With querying cmd-db would not need this enum. >> + >> /* >> * Here's a high level overview of how all the registers in RPMH work >> * together: >> @@ -557,7 +568,15 @@ static int check_for_req_inflight(struct rsc_drv *drv, struct tcs_group *tcs, >> for_each_set_bit(j, &curr_enabled, MAX_CMDS_PER_TCS) { >> addr = read_tcs_cmd(drv, drv->regs[RSC_DRV_CMD_ADDR], i, j); >> for (k = 0; k < msg->num_cmds; k++) { >> - if (addr == msg->cmds[k].addr) >> + /* >> + * Each RPMh VREG accelerator resource has 3 or 4 contiguous 4-byte >> + * aligned addresses associated with it. Ignore the offset to check >> + * for in-flight VREG requests. >> + */ >> + if (ACCL_TYPE(msg->cmds[k].addr) == HW_ACCL_VREG && >> + VREG_ADDR(msg->cmds[k].addr) == VREG_ADDR(addr)) > > I'm sure this work, at least for some targets, but I don't fancy > encoding this information here. It feels like a hack. > > Furthermore, I really would like TP_printk() of trace_rpmh_send_msg() to > be able to resolve the symbolic names for VRMs as well, and it would > need the same information... I can update in separate patch for trace_() to resolve symbolic names. > > Please consider how we can query command db for the type and/or grouping > information. Sure, i will update in v3 to query command db for the type. Thanks, Maulik
Hi, On 1/19/2024 9:17 PM, Andrew Halaney wrote: >> Signed-off-by: Maulik Shah <quic_mkshah@quicinc.com> >> Signed-off-by: Elliot Berman <quic_eberman@quicinc.com> > > Just noticed I commented on v1 when v2 was already out, sorry. Copy > pasting this just to keep it on the latest thread: > > Two minor things: > > 1. Does this deserve a Fixes: tag? > 2. The Signed-off-by chain here confuses me, you sent the patch > so your SOB should be last, but then that makes me believe Elliot > was the author which I don't think is reflected here (no From: > line). Please read [0] for a bit more details > > [0] https://www.kernel.org/doc/html/latest/process/submitting-patches.html#developer-s-certificate-of-origin-1-1 Yes, this looks good to have patch, will include fixes: tag and will fix SOB in v3. Thanks, Maulik
diff --git a/drivers/soc/qcom/rpmh-rsc.c b/drivers/soc/qcom/rpmh-rsc.c index a021dc71807b..e480cde783fe 100644 --- a/drivers/soc/qcom/rpmh-rsc.c +++ b/drivers/soc/qcom/rpmh-rsc.c @@ -1,11 +1,13 @@ // SPDX-License-Identifier: GPL-2.0 /* * Copyright (c) 2016-2018, The Linux Foundation. All rights reserved. + * Copyright (c) 2023-2024, Qualcomm Innovation Center, Inc. All rights reserved. */ #define pr_fmt(fmt) "%s " fmt, KBUILD_MODNAME #include <linux/atomic.h> +#include <linux/bitfield.h> #include <linux/cpu_pm.h> #include <linux/delay.h> #include <linux/interrupt.h> @@ -91,6 +93,15 @@ enum { #define CMD_STATUS_ISSUED BIT(8) #define CMD_STATUS_COMPL BIT(16) +#define ACCL_TYPE(addr) FIELD_GET(GENMASK(19, 16), addr) +#define VREG_ADDR(addr) FIELD_GET(GENMASK(19, 4), addr) + +enum { + HW_ACCL_CLK = 0x3, + HW_ACCL_VREG, + HW_ACCL_BUS, +}; + /* * Here's a high level overview of how all the registers in RPMH work * together: @@ -557,7 +568,15 @@ static int check_for_req_inflight(struct rsc_drv *drv, struct tcs_group *tcs, for_each_set_bit(j, &curr_enabled, MAX_CMDS_PER_TCS) { addr = read_tcs_cmd(drv, drv->regs[RSC_DRV_CMD_ADDR], i, j); for (k = 0; k < msg->num_cmds; k++) { - if (addr == msg->cmds[k].addr) + /* + * Each RPMh VREG accelerator resource has 3 or 4 contiguous 4-byte + * aligned addresses associated with it. Ignore the offset to check + * for in-flight VREG requests. + */ + if (ACCL_TYPE(msg->cmds[k].addr) == HW_ACCL_VREG && + VREG_ADDR(msg->cmds[k].addr) == VREG_ADDR(addr)) + return -EBUSY; + else if (addr == msg->cmds[k].addr) return -EBUSY; } }