new file mode 100644
@@ -0,0 +1,21 @@
+Generic cpufreq driver based on clk and regulator APIs
+
+Required properties in /cpus/cpu@0:
+- cpu-freqs : cpu frequency points it supports, in unit of Hz.
+ Each point takes on cell.
+- cpu-volts : cpu voltage ranges required by the frequency points
+ at the same index, in unit of uV.
+ Each range takes two cells, one for min, the other for max.
+- clk-trans-latency : cpu clk transition latency, in unit of ns.
+ It takes one cell.
+
+An example:
+cpu@0 {
+ cpu-freqs = <996000000 792000000 396000000 198000000>;
+ cpu-volts = < /* min max */
+ 1225000 1450000 /* 996M */
+ 1100000 1450000 /* 792M */
+ 950000 1450000 /* 396M */
+ 850000 1450000>; /* 198M */
+ clk-trans-latency = <61036>; /* two CLK32 periods */
+};
@@ -179,6 +179,16 @@ config CPU_FREQ_GOV_CONSERVATIVE
If in doubt, say N.
+config CLK_REG_CPUFREQ_DRIVER
+ tristate "Generic cpufreq driver using clk and regulator APIs"
+ depends on HAVE_CLK && OF && REGULATOR
+ select CPU_FREQ_TABLE
+ help
+ This adds generic CPUFreq driver based on clk and regulator APIs.
+ It assumes all cores of the CPU share the same clock and voltage.
+
+ If in doubt, say N.
+
menu "x86 CPU frequency scaling drivers"
depends on X86
source "drivers/cpufreq/Kconfig.x86"
@@ -13,6 +13,8 @@ obj-$(CONFIG_CPU_FREQ_GOV_CONSERVATIVE) += cpufreq_conservative.o
# CPUfreq cross-arch helpers
obj-$(CONFIG_CPU_FREQ_TABLE) += freq_table.o
+obj-$(CONFIG_CLK_REG_CPUFREQ_DRIVER) += clk-reg-cpufreq.o
+
##################################################################################
# x86 drivers.
# Link order matters. K8 is preferred to ACPI because of firmware bugs in early
new file mode 100644
@@ -0,0 +1,302 @@
+/*
+ * Copyright (C) 2011 Freescale Semiconductor, Inc.
+ */
+
+/*
+ * The code contained herein is licensed under the GNU General Public
+ * License. You may obtain a copy of the GNU General Public License
+ * Version 2 or later at the following locations:
+ *
+ * http://www.opensource.org/licenses/gpl-license.html
+ * http://www.gnu.org/copyleft/gpl.html
+ */
+
+#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
+
+#include <linux/module.h>
+#include <linux/cpufreq.h>
+#include <linux/clk.h>
+#include <linux/regulator/consumer.h>
+#include <linux/err.h>
+#include <linux/slab.h>
+#include <linux/of.h>
+
+static u32 *cpu_freqs; /* Hz */
+static u32 *cpu_volts; /* uV */
+static u32 trans_latency; /* ns */
+static int cpu_op_nr;
+static unsigned int cur_index;
+
+static struct clk *cpu_clk;
+static struct regulator *cpu_reg;
+static struct cpufreq_frequency_table *freq_table;
+
+static int set_cpu_freq(unsigned long freq, int index, int higher)
+{
+ int ret = 0;
+
+ if (higher && cpu_reg) {
+ ret = regulator_set_voltage(cpu_reg,
+ cpu_volts[index * 2], cpu_volts[index * 2 + 1]);
+ if (ret) {
+ pr_err("set cpu voltage failed!\n");
+ return ret;
+ }
+ }
+
+ ret = clk_set_rate(cpu_clk, freq);
+ if (ret) {
+ if (cpu_reg)
+ regulator_set_voltage(cpu_reg, cpu_volts[cur_index * 2],
+ cpu_volts[cur_index * 2 + 1]);
+ pr_err("cannot set CPU clock rate\n");
+ return ret;
+ }
+
+ if (!higher && cpu_reg) {
+ ret = regulator_set_voltage(cpu_reg,
+ cpu_volts[index * 2], cpu_volts[index * 2 + 1]);
+ if (ret)
+ pr_warn("set cpu voltage failed, might run on"
+ " higher voltage!\n");
+ ret = 0;
+ }
+
+ return ret;
+}
+
+static int clk_reg_verify_speed(struct cpufreq_policy *policy)
+{
+ return cpufreq_frequency_table_verify(policy, freq_table);
+}
+
+static unsigned int clk_reg_get_speed(unsigned int cpu)
+{
+ return clk_get_rate(cpu_clk) / 1000;
+}
+
+static int clk_reg_set_target(struct cpufreq_policy *policy,
+ unsigned int target_freq, unsigned int relation)
+{
+ struct cpufreq_freqs freqs;
+ unsigned long freq_Hz;
+ int cpu;
+ int ret = 0;
+ unsigned int index;
+
+ cpufreq_frequency_table_target(policy, freq_table,
+ target_freq, relation, &index);
+ freq_Hz = clk_round_rate(cpu_clk, cpu_freqs[index]);
+ freq_Hz = freq_Hz ? freq_Hz : cpu_freqs[index];
+ freqs.old = clk_get_rate(cpu_clk) / 1000;
+ freqs.new = freq_Hz / 1000;
+ freqs.flags = 0;
+
+ if (freqs.old == freqs.new)
+ return 0;
+
+ for_each_possible_cpu(cpu) {
+ freqs.cpu = cpu;
+ cpufreq_notify_transition(&freqs, CPUFREQ_PRECHANGE);
+ }
+
+ ret = set_cpu_freq(freq_Hz, index, (freqs.new > freqs.old));
+ if (ret)
+ freqs.new = clk_get_rate(cpu_clk) / 1000;
+ else
+ cur_index = index;
+
+ for_each_possible_cpu(cpu) {
+ freqs.cpu = cpu;
+ cpufreq_notify_transition(&freqs, CPUFREQ_POSTCHANGE);
+ }
+
+ return ret;
+}
+
+static int clk_reg_cpufreq_init(struct cpufreq_policy *policy)
+{
+ int ret;
+
+ if (policy->cpu >= num_possible_cpus())
+ return -EINVAL;
+
+ policy->cur = clk_get_rate(cpu_clk) / 1000;
+ policy->shared_type = CPUFREQ_SHARED_TYPE_ANY;
+ cpumask_setall(policy->cpus);
+ policy->cpuinfo.transition_latency = trans_latency;
+
+ ret = cpufreq_frequency_table_cpuinfo(policy, freq_table);
+
+ if (ret < 0) {
+ pr_err("invalid frequency table for cpu %d\n",
+ policy->cpu);
+ return ret;
+ }
+
+ cpufreq_frequency_table_get_attr(freq_table, policy->cpu);
+ cpufreq_frequency_table_target(policy, freq_table, policy->cur,
+ CPUFREQ_RELATION_H, &cur_index);
+ return 0;
+}
+
+static int clk_reg_cpufreq_exit(struct cpufreq_policy *policy)
+{
+ cpufreq_frequency_table_put_attr(policy->cpu);
+ return 0;
+}
+
+static struct cpufreq_driver clk_reg_cpufreq_driver = {
+ .flags = CPUFREQ_STICKY,
+ .verify = clk_reg_verify_speed,
+ .target = clk_reg_set_target,
+ .get = clk_reg_get_speed,
+ .init = clk_reg_cpufreq_init,
+ .exit = clk_reg_cpufreq_exit,
+ .name = "clk-reg",
+};
+
+static u32 max_freq = UINT_MAX / 1000; /* kHz */
+module_param(max_freq, uint, 0);
+MODULE_PARM_DESC(max_freq, "max cpu frequency in unit of kHz");
+
+static int __devinit clk_reg_cpufreq_driver_init(void)
+{
+ struct device_node *cpu0;
+ const struct property *pp;
+ int max_idx = 0, min_idx = 0;
+ int i, ret;
+
+ cpu0 = of_find_node_by_path("/cpus/cpu@0");
+ if (!cpu0)
+ return -ENODEV;
+
+ pp = of_find_property(cpu0, "cpu-freqs", NULL);
+ if (!pp) {
+ ret = -ENODEV;
+ goto put_node;
+ }
+ cpu_op_nr = pp->length / sizeof(u32);
+ if (!cpu_op_nr) {
+ ret = -ENODEV;
+ goto put_node;
+ }
+ ret = -ENOMEM;
+ cpu_freqs = kzalloc(sizeof(*cpu_freqs) * cpu_op_nr, GFP_KERNEL);
+ if (!cpu_freqs)
+ goto put_node;
+ of_property_read_u32_array(cpu0, "cpu-freqs", cpu_freqs, cpu_op_nr);
+
+ pp = of_find_property(cpu0, "cpu-volts", NULL);
+ if (pp) {
+ if (cpu_op_nr * 2 == pp->length / sizeof(u32)) {
+ cpu_volts = kzalloc(sizeof(*cpu_volts) * cpu_op_nr * 2,
+ GFP_KERNEL);
+ if (!cpu_volts)
+ goto free_cpu_freqs;
+ of_property_read_u32_array(cpu0, "cpu-volts",
+ cpu_volts, cpu_op_nr * 2);
+ } else
+ pr_warn("invalid cpu_volts!\n");
+ }
+
+ if (of_property_read_u32(cpu0, "clk-trans-latency", &trans_latency))
+ trans_latency = CPUFREQ_ETERNAL;
+
+ cpu_clk = clk_get(NULL, "cpu");
+ if (IS_ERR(cpu_clk)) {
+ pr_err("failed to get cpu clock\n");
+ ret = PTR_ERR(cpu_clk);
+ goto free_cpu_volts;
+ }
+
+ if (cpu_volts) {
+ cpu_reg = regulator_get(NULL, "cpu");
+ if (IS_ERR(cpu_reg)) {
+ pr_warn("regulator cpu get failed.\n");
+ cpu_reg = NULL;
+ }
+ }
+
+ freq_table = kmalloc(sizeof(struct cpufreq_frequency_table)
+ * (cpu_op_nr + 1), GFP_KERNEL);
+ if (!freq_table) {
+ ret = -ENOMEM;
+ goto reg_put;
+ }
+
+ for (i = 0; i < cpu_op_nr; i++) {
+ freq_table[i].index = i;
+ if (cpu_freqs[i] > max_freq * 1000) {
+ freq_table[i].frequency = CPUFREQ_ENTRY_INVALID;
+ continue;
+ }
+
+ if (cpu_reg) {
+ ret = regulator_is_supported_voltage(cpu_reg,
+ cpu_volts[i * 2], cpu_volts[i * 2 + 1]);
+ if (ret <= 0) {
+ freq_table[i].frequency = CPUFREQ_ENTRY_INVALID;
+ continue;
+ }
+ }
+ freq_table[i].frequency = cpu_freqs[i] / 1000;
+ max_idx = cpu_freqs[i] > cpu_freqs[max_idx] ? i : max_idx;
+ min_idx = cpu_freqs[i] < cpu_freqs[min_idx] ? i : min_idx;
+ }
+
+ freq_table[i].index = i;
+ freq_table[i].frequency = CPUFREQ_TABLE_END;
+
+ if (cpu_reg && trans_latency != CPUFREQ_ETERNAL) {
+ ret = regulator_set_voltage_time(cpu_reg, cpu_volts[min_idx],
+ cpu_volts[max_idx]);
+ if (ret < 0) {
+ pr_warn("regulator_set_voltage_time failed. "
+ "Default use 1us\n");
+ ret = 1;
+ }
+ trans_latency += ret * 1000;
+ }
+
+ ret = cpufreq_register_driver(&clk_reg_cpufreq_driver);
+ if (ret)
+ goto free_freq_table;
+
+ of_node_put(cpu0);
+
+ return 0;
+
+free_freq_table:
+ kfree(freq_table);
+reg_put:
+ if (cpu_reg)
+ regulator_put(cpu_reg);
+ clk_put(cpu_clk);
+free_cpu_volts:
+ kfree(cpu_volts);
+free_cpu_freqs:
+ kfree(cpu_freqs);
+put_node:
+ of_node_put(cpu0);
+
+ return ret;
+}
+
+static void clk_reg_cpufreq_driver_exit(void)
+{
+ cpufreq_unregister_driver(&clk_reg_cpufreq_driver);
+ kfree(cpu_freqs);
+ kfree(cpu_volts);
+ clk_put(cpu_clk);
+ if (cpu_reg)
+ regulator_put(cpu_reg);
+ kfree(freq_table);
+}
+
+module_init(clk_reg_cpufreq_driver_init);
+module_exit(clk_reg_cpufreq_driver_exit);
+
+MODULE_AUTHOR("Freescale Semiconductor Inc. Richard Zhao <richard.zhao@freescale.com>");
+MODULE_DESCRIPTION("Generic CPUFreq driver based on clk and regulator APIs");
+MODULE_LICENSE("GPL");