| Message ID | 20241017042300.872963-4-quic_liuxin@quicinc.com |
|---|---|
| State | New |
| Headers | show |
| Series | Enable UFS on QCS615 | expand |
On 17.10.2024 6:22 AM, Xin Liu wrote: > From: Sayali Lokhande <quic_sayalil@quicinc.com> > > Add the UFS Host Controller node and its PHY for QCS615 SoC. > > Signed-off-by: Sayali Lokhande <quic_sayalil@quicinc.com> > Co-developed-by: Xin Liu <quic_liuxin@quicinc.com> > Signed-off-by: Xin Liu <quic_liuxin@quicinc.com> > --- + Taniya (see below) > arch/arm64/boot/dts/qcom/qcs615.dtsi | 74 ++++++++++++++++++++++++++++ > 1 file changed, 74 insertions(+) > > diff --git a/arch/arm64/boot/dts/qcom/qcs615.dtsi b/arch/arm64/boot/dts/qcom/qcs615.dtsi > index fcba83fca7cf..689418466dc2 100644 > --- a/arch/arm64/boot/dts/qcom/qcs615.dtsi > +++ b/arch/arm64/boot/dts/qcom/qcs615.dtsi > @@ -458,6 +458,80 @@ mmss_noc: interconnect@1740000 { > qcom,bcm-voters = <&apps_bcm_voter>; > }; > > + ufs_mem_hc: ufs@1d84000 { ufshc@ would be consistent with other files in dts/qcom > + compatible = "qcom,qcs615-ufshc", "qcom,ufshc", "jedec,ufs-2.0"; > + reg = <0x0 0x01d84000 0x0 0x3000>, <0x0 0x01d90000 0x0 0x8000>; > + reg-names = "std", "ice"; One per line, please > + interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>; > + phys = <&ufs_mem_phy>; > + phy-names = "ufsphy"; > + lanes-per-direction = <1>; > + #reset-cells = <1>; > + resets = <&gcc GCC_UFS_PHY_BCR>; > + reset-names = "rst"; > + > + power-domains = <&gcc UFS_PHY_GDSC>; > + required-opps = <&rpmhpd_opp_nom>; > + > + iommus = <&apps_smmu 0x300 0x0>; > + dma-coherent; > + > + interconnects = <&aggre1_noc MASTER_UFS_MEM QCOM_ICC_TAG_ALWAYS > + &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>, > + <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS > + &config_noc SLAVE_UFS_MEM_CFG QCOM_ICC_TAG_ALWAYS>; > + interconnect-names = "ufs-ddr", > + "cpu-ufs"; > + > + clocks = <&gcc GCC_UFS_PHY_AXI_CLK>, > + <&gcc GCC_AGGRE_UFS_PHY_AXI_CLK>, > + <&gcc GCC_UFS_PHY_AHB_CLK>, > + <&gcc GCC_UFS_PHY_UNIPRO_CORE_CLK>, > + <&rpmhcc RPMH_CXO_CLK>, > + <&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>, > + <&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>, > + <&gcc GCC_UFS_PHY_ICE_CORE_CLK>; > + clock-names = "core_clk", > + "bus_aggr_clk", > + "iface_clk", > + "core_clk_unipro", > + "ref_clk", > + "tx_lane0_sync_clk", > + "rx_lane0_sync_clk", > + "ice_core_clk"; > + freq-table-hz = <50000000 200000000>, > + <0 0>, > + <0 0>, > + <37500000 150000000>, > + <0 0>, > + <0 0>, > + <0 0>, > + <75000000 300000000>; Please try to match the order of properties present in sm8650.dtsi And please use an OPP table instead of freq-table-hz (see sm8*5*50.dtsi) > + > + status = "disabled"; > + }; > + > + ufs_mem_phy: phy@1d87000 { > + compatible = "qcom,qcs615-qmp-ufs-phy", "qcom,sm6115-qmp-ufs-phy"; > + reg = <0x0 0x01d87000 0x0 0xe00>; This register region is a bit longer > + clocks = <&rpmhcc RPMH_CXO_CLK>, > + <&gcc GCC_UFS_PHY_PHY_AUX_CLK>, > + <&gcc GCC_UFS_MEM_CLKREF_CLK>; > + clock-names = "ref", > + "ref_aux", > + "qref"; > + > + power-domains = <&gcc UFS_PHY_GDSC>; > + > + resets = <&ufs_mem_hc 0>; > + reset-names = "ufsphy"; > + > + #clock-cells = <1>; The PHY is a clock provider. Normally, it's a parent of gcc_ufs_phy_[rt]x_symbol_n clocks. Taniya, could you please wire that up in your patchset? Konrad
diff --git a/arch/arm64/boot/dts/qcom/qcs615.dtsi b/arch/arm64/boot/dts/qcom/qcs615.dtsi index fcba83fca7cf..689418466dc2 100644 --- a/arch/arm64/boot/dts/qcom/qcs615.dtsi +++ b/arch/arm64/boot/dts/qcom/qcs615.dtsi @@ -458,6 +458,80 @@ mmss_noc: interconnect@1740000 { qcom,bcm-voters = <&apps_bcm_voter>; }; + ufs_mem_hc: ufs@1d84000 { + compatible = "qcom,qcs615-ufshc", "qcom,ufshc", "jedec,ufs-2.0"; + reg = <0x0 0x01d84000 0x0 0x3000>, <0x0 0x01d90000 0x0 0x8000>; + reg-names = "std", "ice"; + interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>; + phys = <&ufs_mem_phy>; + phy-names = "ufsphy"; + lanes-per-direction = <1>; + #reset-cells = <1>; + resets = <&gcc GCC_UFS_PHY_BCR>; + reset-names = "rst"; + + power-domains = <&gcc UFS_PHY_GDSC>; + required-opps = <&rpmhpd_opp_nom>; + + iommus = <&apps_smmu 0x300 0x0>; + dma-coherent; + + interconnects = <&aggre1_noc MASTER_UFS_MEM QCOM_ICC_TAG_ALWAYS + &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>, + <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS + &config_noc SLAVE_UFS_MEM_CFG QCOM_ICC_TAG_ALWAYS>; + interconnect-names = "ufs-ddr", + "cpu-ufs"; + + clocks = <&gcc GCC_UFS_PHY_AXI_CLK>, + <&gcc GCC_AGGRE_UFS_PHY_AXI_CLK>, + <&gcc GCC_UFS_PHY_AHB_CLK>, + <&gcc GCC_UFS_PHY_UNIPRO_CORE_CLK>, + <&rpmhcc RPMH_CXO_CLK>, + <&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>, + <&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>, + <&gcc GCC_UFS_PHY_ICE_CORE_CLK>; + clock-names = "core_clk", + "bus_aggr_clk", + "iface_clk", + "core_clk_unipro", + "ref_clk", + "tx_lane0_sync_clk", + "rx_lane0_sync_clk", + "ice_core_clk"; + freq-table-hz = <50000000 200000000>, + <0 0>, + <0 0>, + <37500000 150000000>, + <0 0>, + <0 0>, + <0 0>, + <75000000 300000000>; + + status = "disabled"; + }; + + ufs_mem_phy: phy@1d87000 { + compatible = "qcom,qcs615-qmp-ufs-phy", "qcom,sm6115-qmp-ufs-phy"; + reg = <0x0 0x01d87000 0x0 0xe00>; + clocks = <&rpmhcc RPMH_CXO_CLK>, + <&gcc GCC_UFS_PHY_PHY_AUX_CLK>, + <&gcc GCC_UFS_MEM_CLKREF_CLK>; + clock-names = "ref", + "ref_aux", + "qref"; + + power-domains = <&gcc UFS_PHY_GDSC>; + + resets = <&ufs_mem_hc 0>; + reset-names = "ufsphy"; + + #clock-cells = <1>; + #phy-cells = <0>; + + status = "disabled"; + }; + tcsr_mutex: hwlock@1f40000 { compatible = "qcom,tcsr-mutex"; reg = <0x0 0x01f40000 0x0 0x20000>;