@@ -1420,7 +1420,7 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
dev_err(&pdev->dev,
"can't request rdy gpio %d\n",
host->board.rdy_pin);
- goto err_ecc_ioremap;
+ goto err_no_card;
}
res = gpio_direction_input(host->board.rdy_pin);
@@ -1428,7 +1428,7 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
dev_err(&pdev->dev,
"can't request input direction rdy gpio %d\n",
host->board.rdy_pin);
- goto err_ecc_ioremap;
+ goto err_no_card;
}
nand_chip->dev_ready = atmel_nand_device_ready;
@@ -1440,7 +1440,7 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
dev_err(&pdev->dev,
"can't request enable gpio %d\n",
host->board.enable_pin);
- goto err_ecc_ioremap;
+ goto err_no_card;
}
res = gpio_direction_output(host->board.enable_pin, 1);
@@ -1448,7 +1448,7 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
dev_err(&pdev->dev,
"can't request output direction enable gpio %d\n",
host->board.enable_pin);
- goto err_ecc_ioremap;
+ goto err_no_card;
}
}
The atmel_nand driver was broken by b654a9a46fc2 "mtd: atmel nand: fix gpio missing request". This is a rather helpless attempt to fix this, probably messing up the error handling even further but getting the build to work again, so please treat it as a bug report rather than a fix to be applied. Without this patch, building any at91 configuration results in: drivers/mtd/nand/atmel_nand.c: In function 'atmel_nand_probe': drivers/mtd/nand/atmel_nand.c:1451:4: error: label 'err_ecc_ioremap' used but not defined Signed-off-by: Arnd Bergmann <arnd@arndb.de> Cc: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com> Cc: Artem Bityutskiy <artem.bityutskiy@linux.intel.com> --- drivers/mtd/nand/atmel_nand.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)