diff mbox series

[3/4] warp7: include: configs: set skip low level init

Message ID 20180905105608.453-4-bryan.odonoghue@linaro.org
State New
Headers show
Series Add WaRP7 ATF chainloaded setup | expand

Commit Message

Bryan O'Donoghue Sept. 5, 2018, 10:56 a.m. UTC 
From: Rui Miguel Silva <rui.silva@linaro.org>

If we have defined the OPTEE ram size and not OPTEE means that we are in
the case where OPTEE is loaded already (maybe by ARM Trusted Firmware) and
that most of the low level initialization is already done and that we
may/should skip it doing them here.

Signed-off-by: Rui Miguel Silva <rui.silva@linaro.org>
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Cc: Fabio Estevam <fabio.estevam@nxp.com>
Cc: u-boot@lists.denx.de
---
 include/configs/warp7.h | 11 +++++++++++
 1 file changed, 11 insertions(+)
diff mbox series

Patch

diff --git a/include/configs/warp7.h b/include/configs/warp7.h
index 1b656a5aaf..a391dfb5c1 100644
--- a/include/configs/warp7.h
+++ b/include/configs/warp7.h
@@ -13,6 +13,17 @@ 
 
 #define PHYS_SDRAM_SIZE			SZ_512M
 
+/*
+ * If we have defined the OPTEE ram size and not OPTEE it means that we were
+ * launched by OPTEE, because of that we shall skip all the low level
+ * initialization since it was already done by ATF or OPTEE
+ */
+#ifdef CONFIG_OPTEE_TZDRAM_SIZE
+#ifndef CONFIG_OPTEE
+#define CONFIG_SKIP_LOWLEVEL_INIT
+#endif
+#endif
+
 #define CONFIG_MXC_UART_BASE		UART1_IPS_BASE_ADDR
 
 /* Size of malloc() pool */