@@ -17,6 +17,7 @@
aliases {
serial0 = &uart9;
+ hsuart0 = &uart6;
};
chosen {
@@ -357,6 +358,10 @@
clock-frequency = <400000>;
};
+&qupv3_id_0 {
+ status = "okay";
+};
+
&qupv3_id_1 {
status = "okay";
};
@@ -373,6 +378,20 @@
cd-gpios = <&tlmm 126 GPIO_ACTIVE_LOW>;
};
+&uart6 {
+ status = "okay";
+
+ bluetooth {
+ compatible = "qcom,wcn3990-bt";
+
+ vddio-supply = <&vreg_s4a_1p8>;
+ vddxo-supply = <&vreg_l7a_1p8>;
+ vddrf-supply = <&vreg_l17a_1p3>;
+ vddch0-supply = <&vreg_l25a_3p3>;
+ max-speed = <3200000>;
+ };
+};
+
&uart9 {
status = "okay";
};
@@ -470,6 +489,40 @@
};
};
+&qup_uart6_default {
+ pinmux {
+ pins = "gpio45", "gpio46", "gpio47", "gpio48";
+ function = "qup6";
+ };
+
+ cts {
+ /*
+ * Configure a pull-down on 45 (CTS) to match the pull of
+ * the Bluetooth module.
+ */
+ pins = "gpio45";
+ bias-pull-down;
+ };
+
+ rts-tx {
+ /* We'll drive 46 (RTS) and 47 (TX), so no pull */
+ pins = "gpio46", "gpio47";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ rx {
+ /*
+ * Configure a pull-up on 48 (RX). This is needed to avoid
+ * garbage data when the TX pin of the Bluetooth module is
+ * in tri-state (module powered off or not driving the
+ * signal yet).
+ */
+ pins = "gpio48";
+ bias-pull-up;
+ };
+};
+
&qup_uart9_default {
pinconf-tx {
pins = "gpio4";
The SDM845 MTP has a WCN3990 Bluetooth chip on UART6, enable this. Pinconf and the associated comments are copied from a patch by Matthias Kaehlcke <mka@chromium.org>. Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org> --- Changes since v1: - Fixed the pinconf arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 53 +++++++++++++++++++++++++ 1 file changed, 53 insertions(+) -- 2.18.0