@@ -420,7 +420,7 @@ qca8k_mib_init(struct qca8k_priv *priv)
static int
qca8k_set_pad_ctrl(struct qca8k_priv *priv, int port, int mode)
{
- u32 reg;
+ u32 reg, val;
switch (port) {
case 0:
@@ -439,17 +439,9 @@ qca8k_set_pad_ctrl(struct qca8k_priv *priv, int port, int mode)
*/
switch (mode) {
case PHY_INTERFACE_MODE_RGMII:
- qca8k_write(priv, reg,
- QCA8K_PORT_PAD_RGMII_EN |
- QCA8K_PORT_PAD_RGMII_TX_DELAY(3) |
- QCA8K_PORT_PAD_RGMII_RX_DELAY(3));
-
- /* According to the datasheet, RGMII delay is enabled through
- * PORT5_PAD_CTRL for all ports, rather than individual port
- * registers
- */
- qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL,
- QCA8K_PORT_PAD_RGMII_RX_DELAY_EN);
+ /* RGMII mode means no delay so don't enable the delay */
+ val = QCA8K_PORT_PAD_RGMII_EN;
+ qca8k_write(priv, reg, val);
break;
case PHY_INTERFACE_MODE_SGMII:
qca8k_write(priv, reg, QCA8K_PORT_PAD_SGMII_EN);
In RGMII mode we should not have any delay in port MAC, so disable the delay. Signed-off-by: Vinod Koul <vkoul@kernel.org> --- drivers/net/dsa/qca8k.c | 16 ++++------------ 1 file changed, 4 insertions(+), 12 deletions(-) -- 2.20.1