Message ID | 20190219065943.22765-1-vkoul@kernel.org |
---|---|
State | Accepted |
Commit | a968b5e9d5879f9535d6099505f9e14abcafb623 |
Headers | show |
Series | [net-next,v2] net: dsa: qca8k: Enable delay for RGMII_ID mode | expand |
On Tue, Feb 19, 2019 at 12:29:43PM +0530, Vinod Koul wrote: > RGMII_ID specifies that we should have internal delay, so resurrect the > delay addition routine but under the RGMII_ID mode. > > Fixes: 40269aa9f40a ("net: dsa: qca8k: disable delay for RGMII mode") > Tested-by: Michal Vokáč <michal.vokac@ysoft.com> > Signed-off-by: Vinod Koul <vkoul@kernel.org> Reviewed-by: Andrew Lunn <andrew@lunn.ch> Andrew
diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c index a4b6cda38016..195a8a87b984 100644 --- a/drivers/net/dsa/qca8k.c +++ b/drivers/net/dsa/qca8k.c @@ -443,6 +443,18 @@ qca8k_set_pad_ctrl(struct qca8k_priv *priv, int port, int mode) val = QCA8K_PORT_PAD_RGMII_EN; qca8k_write(priv, reg, val); break; + case PHY_INTERFACE_MODE_RGMII_ID: + /* RGMII_ID needs internal delay. This is enabled through + * PORT5_PAD_CTRL for all ports, rather than individual port + * registers + */ + qca8k_write(priv, reg, + QCA8K_PORT_PAD_RGMII_EN | + QCA8K_PORT_PAD_RGMII_TX_DELAY(QCA8K_MAX_DELAY) | + QCA8K_PORT_PAD_RGMII_RX_DELAY(QCA8K_MAX_DELAY)); + qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL, + QCA8K_PORT_PAD_RGMII_RX_DELAY_EN); + break; case PHY_INTERFACE_MODE_SGMII: qca8k_write(priv, reg, QCA8K_PORT_PAD_SGMII_EN); break; diff --git a/drivers/net/dsa/qca8k.h b/drivers/net/dsa/qca8k.h index 613fe5c50236..d146e54c8a6c 100644 --- a/drivers/net/dsa/qca8k.h +++ b/drivers/net/dsa/qca8k.h @@ -40,6 +40,7 @@ ((0x8 + (x & 0x3)) << 22) #define QCA8K_PORT_PAD_RGMII_RX_DELAY(x) \ ((0x10 + (x & 0x3)) << 20) +#define QCA8K_MAX_DELAY 3 #define QCA8K_PORT_PAD_RGMII_RX_DELAY_EN BIT(24) #define QCA8K_PORT_PAD_SGMII_EN BIT(7) #define QCA8K_REG_MODULE_EN 0x030