diff mbox

[02/10] usb: musb: ux500: move the MUSB HDRC configuration into the driver

Message ID 1366729394-11406-3-git-send-email-lee.jones@linaro.org
State Superseded
Headers show

Commit Message

Lee Jones April 23, 2013, 3:03 p.m. UTC 
The MUSB HDRC configuration never changes between each of the ux500
supported platforms, so there's little point passing it though platform
data. If we set it in the driver instead, we can make good use of it
when booting with either ATAGs or Device Tree.

Cc: Felipe Balbi <balbi@ti.com>
Cc: linux-usb@vger.kernel.org
Signed-off-by: Lee Jones <lee.jones@linaro.org>
---
 arch/arm/mach-ux500/usb.c |    8 --------
 drivers/usb/musb/ux500.c  |    8 ++++++++
 2 files changed, 8 insertions(+), 8 deletions(-)
diff mbox

Patch

diff --git a/arch/arm/mach-ux500/usb.c b/arch/arm/mach-ux500/usb.c
index 8aff9a4..4f68a9c 100644
--- a/arch/arm/mach-ux500/usb.c
+++ b/arch/arm/mach-ux500/usb.c
@@ -76,16 +76,8 @@  static struct ux500_musb_board_data musb_board_data = {
 
 static u64 ux500_musb_dmamask = DMA_BIT_MASK(32);
 
-static struct musb_hdrc_config musb_hdrc_config = {
-	.multipoint	= true,
-	.dyn_fifo	= true,
-	.num_eps	= 16,
-	.ram_bits	= 16,
-};
-
 static struct musb_hdrc_platform_data musb_platform_data = {
 	.mode = MUSB_OTG,
-	.config = &musb_hdrc_config,
 	.board_data = &musb_board_data,
 };
 
diff --git a/drivers/usb/musb/ux500.c b/drivers/usb/musb/ux500.c
index 13a3929..4a8f5c9 100644
--- a/drivers/usb/musb/ux500.c
+++ b/drivers/usb/musb/ux500.c
@@ -29,6 +29,13 @@ 
 
 #include "musb_core.h"
 
+static struct musb_hdrc_config ux500_musb_hdrc_config = {
+	.multipoint	= true,
+	.dyn_fifo	= true,
+	.num_eps	= 16,
+	.ram_bits	= 16,
+};
+
 struct ux500_glue {
 	struct device		*dev;
 	struct platform_device	*musb;
@@ -123,6 +130,7 @@  static int ux500_probe(struct platform_device *pdev)
 	glue->clk			= clk;
 
 	pdata->platform_ops		= &ux500_ops;
+	pdata->config 			= &ux500_musb_hdrc_config;
 
 	platform_set_drvdata(pdev, glue);