diff mbox series

[1/2] dt-bindings: pinctrl: meson: add output support in pinconf

Message ID 20190516151339.25846-2-jbrunet@baylibre.com
State New
Headers show
Series [1/2] dt-bindings: pinctrl: meson: add output support in pinconf | expand

Commit Message

Jerome Brunet May 16, 2019, 3:13 p.m. UTC
add support for the pinconf DT property output-enable, output-disable,
output-low and output-high in the meson pinctrl driver.

Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>

---
 .../devicetree/bindings/pinctrl/meson,pinctrl.txt    | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)

-- 
2.20.1

Comments

Linus Walleij May 24, 2019, 11:49 a.m. UTC | #1
On Thu, May 16, 2019 at 5:13 PM Jerome Brunet <jbrunet@baylibre.com> wrote:

> add support for the pinconf DT property output-enable, output-disable,

> output-low and output-high in the meson pinctrl driver.

>

> Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>


Only standard properties so patch applied as obviously correct.

Yours,
Linus Walleij
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
index a7618605bf1e..10dc4f7176ca 100644
--- a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
@@ -47,9 +47,15 @@  Required properties for pinmux nodes are:
 Required properties for configuration nodes:
  - pins: a list of pin names
 
-Configuration nodes support the generic properties "bias-disable",
-"bias-pull-up" and "bias-pull-down", described in file
-pinctrl-bindings.txt
+Configuration nodes support the following generic properties, as
+described in file pinctrl-bindings.txt:
+ - "bias-disable"
+ - "bias-pull-up"
+ - "bias-pull-down"
+ - "output-enable"
+ - "output-disable"
+ - "output-low"
+ - "output-high"
 
 Optional properties :
  - drive-strength-microamp: Drive strength for the specified pins in uA.