diff mbox

[21/39] usb: musb: ux500: move the MUSB HDRC configuration into the driver

Message ID 1368611522-9984-22-git-send-email-lee.jones@linaro.org
State Accepted
Commit a20b1b791e42d84dedd5854b60abb841ec1a7585
Headers show

Commit Message

Lee Jones May 15, 2013, 9:51 a.m. UTC 
The MUSB HDRC configuration never changes between each of the ux500
supported platforms, so there's little point passing it though platform
data. If we set it in the driver instead, we can make good use of it
when booting with either ATAGs or Device Tree.

Cc: Felipe Balbi <balbi@ti.com>
Cc: linux-usb@vger.kernel.org
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Fabio Baltieri <fabio.baltieri@linaro.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
---
 arch/arm/mach-ux500/usb.c |    8 --------
 drivers/usb/musb/ux500.c  |    8 ++++++++
 2 files changed, 8 insertions(+), 8 deletions(-)
diff mbox

Patch

diff --git a/arch/arm/mach-ux500/usb.c b/arch/arm/mach-ux500/usb.c
index a21c2e1..49d6e57 100644
--- a/arch/arm/mach-ux500/usb.c
+++ b/arch/arm/mach-ux500/usb.c
@@ -76,16 +76,8 @@  static struct ux500_musb_board_data musb_board_data = {
 
 static u64 ux500_musb_dmamask = DMA_BIT_MASK(32);
 
-static struct musb_hdrc_config musb_hdrc_config = {
-	.multipoint	= true,
-	.dyn_fifo	= true,
-	.num_eps	= 16,
-	.ram_bits	= 16,
-};
-
 static struct musb_hdrc_platform_data musb_platform_data = {
 	.mode = MUSB_OTG,
-	.config = &musb_hdrc_config,
 	.board_data = &musb_board_data,
 };
 
diff --git a/drivers/usb/musb/ux500.c b/drivers/usb/musb/ux500.c
index 2c80004..371776f 100644
--- a/drivers/usb/musb/ux500.c
+++ b/drivers/usb/musb/ux500.c
@@ -30,6 +30,13 @@ 
 
 #include "musb_core.h"
 
+static struct musb_hdrc_config ux500_musb_hdrc_config = {
+	.multipoint	= true,
+	.dyn_fifo	= true,
+	.num_eps	= 16,
+	.ram_bits	= 16,
+};
+
 struct ux500_glue {
 	struct device		*dev;
 	struct platform_device	*musb;
@@ -229,6 +236,7 @@  static int ux500_probe(struct platform_device *pdev)
 	glue->clk			= clk;
 
 	pdata->platform_ops		= &ux500_ops;
+	pdata->config 			= &ux500_musb_hdrc_config;
 
 	platform_set_drvdata(pdev, glue);