@@ -1,89 +1 @@
-EEPROMs (I2C)
-
-Required properties:
-
- - compatible: Must be a "<manufacturer>,<model>" pair. The following <model>
- values are supported (assuming "atmel" as manufacturer):
-
- "atmel,24c00",
- "atmel,24c01",
- "atmel,24cs01",
- "atmel,24c02",
- "atmel,24cs02",
- "atmel,24mac402",
- "atmel,24mac602",
- "atmel,spd",
- "atmel,24c04",
- "atmel,24cs04",
- "atmel,24c08",
- "atmel,24cs08",
- "atmel,24c16",
- "atmel,24cs16",
- "atmel,24c32",
- "atmel,24cs32",
- "atmel,24c64",
- "atmel,24cs64",
- "atmel,24c128",
- "atmel,24c256",
- "atmel,24c512",
- "atmel,24c1024",
- "atmel,24c2048",
-
- If <manufacturer> is not "atmel", then a fallback must be used
- with the same <model> and "atmel" as manufacturer.
-
- Example:
- compatible = "microchip,24c128", "atmel,24c128";
-
- Supported manufacturers are:
-
- "catalyst",
- "microchip",
- "nxp",
- "ramtron",
- "renesas",
- "rohm",
- "st",
-
- Some vendors use different model names for chips which are just
- variants of the above. Known such exceptions are listed below:
-
- "nxp,se97b" - the fallback is "atmel,24c02",
- "renesas,r1ex24002" - the fallback is "atmel,24c02"
- "renesas,r1ex24016" - the fallback is "atmel,24c16"
- "renesas,r1ex24128" - the fallback is "atmel,24c128"
- "rohm,br24t01" - the fallback is "atmel,24c01"
-
- - reg: The I2C address of the EEPROM.
-
-Optional properties:
-
- - pagesize: The length of the pagesize for writing. Please consult the
- manual of your device, that value varies a lot. A wrong value
- may result in data loss! If not specified, a safety value of
- '1' is used which will be very slow.
-
- - read-only: This parameterless property disables writes to the eeprom.
-
- - size: Total eeprom size in bytes.
-
- - no-read-rollover: This parameterless property indicates that the
- multi-address eeprom does not automatically roll over
- reads to the next slave address. Please consult the
- manual of your device.
-
- - wp-gpios: GPIO to which the write-protect pin of the chip is connected.
-
- - address-width: number of address bits (one of 8, 16).
-
- - num-addresses: total number of i2c slave addresses this device takes
-
-Example:
-
-eeprom@52 {
- compatible = "atmel,24c32";
- reg = <0x52>;
- pagesize = <32>;
- wp-gpios = <&gpio1 3 0>;
- num-addresses = <8>;
-};
+This file has been moved to at24.yaml.
new file mode 100644
@@ -0,0 +1,164 @@
+# SPDX-License-Identifier: GPL-2.0-only
+# Copyright 2019 BayLibre SAS
+%YAML 1.2
+---
+$id: "http://devicetree.org/schemas/eeprom/at24.yaml#"
+$schema: "http://devicetree.org/meta-schemas/core.yaml#"
+
+title: I2C EEPROMs compatible with Atmel's AT24
+
+maintainers:
+ - Bartosz Golaszewski <bgolaszewski@baylibre.com>
+
+select:
+ properties:
+ compatible:
+ contains:
+ pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
+ required:
+ - compatible
+
+properties:
+ $nodename:
+ pattern: "^eeprom@[0-9a-f]{1,2}$"
+ compatible:
+ oneOf:
+ - allOf:
+ - minItems: 1
+ maxItems: 2
+ items:
+ - pattern: "^(atmel|catalyst|microchip|nxp|ramtron|renesas|rohm|st),(24(c|cs|mac)[0-9]+|spd)$"
+ - pattern: "^atmel,(24(c|cs|mac)[0-9]+|spd)$"
+ - oneOf:
+ - items:
+ pattern: c00$
+ - items:
+ pattern: c01$
+ - items:
+ pattern: c02$
+ - items:
+ pattern: c04$
+ - items:
+ pattern: c08$
+ - items:
+ pattern: c16$
+ - items:
+ pattern: cs16$
+ - items:
+ pattern: c32$
+ - items:
+ pattern: cs32$
+ - items:
+ pattern: c64$
+ - items:
+ pattern: cs64$
+ - items:
+ pattern: c128$
+ - items:
+ pattern: cs128$
+ - items:
+ pattern: c256$
+ - items:
+ pattern: cs256$
+ - items:
+ pattern: c512$
+ - items:
+ pattern: cs512$
+ - items:
+ pattern: c1024$
+ - items:
+ pattern: cs1024$
+ - items:
+ pattern: c2048$
+ - items:
+ pattern: cs2048$
+ - items:
+ pattern: spd$
+ - items:
+ - const: rohm,br24t01
+ - const: atmel,24c01
+ - items:
+ - const: nxp,se97b
+ - const: atmel,24c02
+ - items:
+ - const: renesas,r1ex24002
+ - const: atmel,24c02
+ - items:
+ - const: renesas,r1ex24016
+ - const: atmel,24c16
+ - items:
+ - const: renesas,r1ex24128
+ - const: atmel,24c128
+
+ reg:
+ maxItems: 1
+
+ pagesize:
+ allOf:
+ - $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ The length of the pagesize for writing. Please consult the
+ manual of your device, that value varies a lot. A wrong value
+ may result in data loss! If not specified, a safety value of
+ '1' is used which will be very slow.
+ enum: [ 1, 8, 16, 32, 64, 128, 258 ]
+ default: 1
+
+ read-only:
+ $ref: /schemas/types.yaml#definitions/flag
+ description:
+ This parameterless property disables writes to the eeprom.
+
+ size:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ Total eeprom size in bytes.
+
+ no-read-rollover:
+ $ref: /schemas/types.yaml#definitions/flag
+ description:
+ This parameterless property indicates that the multi-address
+ eeprom does not automatically roll over reads to the next slave
+ address. Please consult the manual of your device.
+
+ wp-gpios:
+ description:
+ GPIO to which the write-protect pin of the chip is connected.
+ maxItems: 1
+
+ address-width:
+ allOf:
+ - $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ Number of address bits (one of 8, 16).
+ default: 8
+ enum: [ 8, 16 ]
+
+ num-addresses:
+ allOf:
+ - $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ Total number of i2c slave addresses this device takes.
+ default: 1
+ minimum: 1
+ maximum: 8
+
+required:
+ - compatible
+ - reg
+
+examples:
+ - |
+ i2c {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ eeprom@52 {
+ compatible = "microchip,24c32", "atmel,24c32";
+ reg = <0x52>;
+ pagesize = <32>;
+ wp-gpios = <&gpio1 3 0>;
+ num-addresses = <8>;
+ };
+ };
+...
@@ -2687,7 +2687,7 @@ M: Bartosz Golaszewski <bgolaszewski@baylibre.com>
L: linux-i2c@vger.kernel.org
T: git git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux.git
S: Maintained
-F: Documentation/devicetree/bindings/eeprom/at24.txt
+F: Documentation/devicetree/bindings/eeprom/at24.yaml
F: drivers/misc/eeprom/at24.c
ATA OVER ETHERNET (AOE) DRIVER