@@ -1,5 +1,6 @@
# SPDX-License-Identifier: GPL-2.0
dtb-$(CONFIG_ARCH_QCOM) += apq8016-sbc.dtb
+dtb-$(CONFIG_ARCH_QCOM) += apq8016-sbc-d3camera.dtb
dtb-$(CONFIG_ARCH_QCOM) += apq8096-db820c.dtb
dtb-$(CONFIG_ARCH_QCOM) += apq8096-ifc6640.dtb
dtb-$(CONFIG_ARCH_QCOM) += ipq6018-cp01-c1.dtb
new file mode 100644
@@ -0,0 +1,45 @@
+// SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause
+/*
+ * Copyright (c) 2020, The Linux Foundation. All rights reserved.
+ */
+
+/dts-v1/;
+
+#include "apq8016-sbc.dtsi"
+
+/ {
+ model = "Qualcomm Technologies, Inc. APQ 8016 SBC w/ D3Camera Mezzanine";
+ compatible = "qcom,apq8016-sbc", "qcom,apq8016", "qcom,sbc";
+};
+
+&cci_i2c0 {
+ /delete-node/ camera_rear@3b;
+
+ camera_rear@76 {
+ compatible = "ovti,ov5640";
+ reg = <0x76>;
+
+ enable-gpios = <&msmgpio 34 GPIO_ACTIVE_HIGH>;
+ reset-gpios = <&msmgpio 35 GPIO_ACTIVE_LOW>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&camera_rear_default>;
+
+ clocks = <&gcc GCC_CAMSS_MCLK0_CLK>;
+ clock-names = "xclk";
+ clock-frequency = <23880000>;
+
+ vdddo-supply = <&camera_vdddo_1v8>;
+ vdda-supply = <&camera_vdda_2v8>;
+ vddd-supply = <&camera_vddd_1v5>;
+
+ status = "ok";
+
+ port {
+ ov5640_ep: endpoint {
+ clock-lanes = <1>;
+ data-lanes = <0 2>;
+ remote-endpoint = <&csiphy0_ep>;
+ };
+ };
+ };
+};
Add device treee support for the Qualcomm APQ8016 SBC, otherwise known as the Dragonboard 410c with the D3Camera mezzanine expansion board. The D3Camera mezzanine ships in a kit with a OmniVision 5640 sensor module, which is what this DT targets. Signed-off-by: Robert Foss <robert.foss@linaro.org> --- Changes since v1: - Vinod: Changed license to GPL+BSD - Vinod: Changed copyright year to 2020 - Nico: Changed name of mezzanine to d3camera arch/arm64/boot/dts/qcom/Makefile | 1 + .../boot/dts/qcom/apq8016-sbc-d3camera.dts | 45 +++++++++++++++++++ 2 files changed, 46 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/apq8016-sbc-d3camera.dts