@@ -1581,6 +1581,49 @@
qcom,bcm-voters = <&apps_bcm_voter>;
};
+ mdp_opp_table: mdp-opp-table {
+ compatible = "operating-points-v2";
+
+ opp-200000000 {
+ opp-hz = /bits/ 64 <200000000>;
+ required-opps = <&rpmhpd_opp_low_svs>;
+ };
+
+ opp-300000000 {
+ opp-hz = /bits/ 64 <300000000>;
+ required-opps = <&rpmhpd_opp_svs>;
+ };
+
+ opp-345000000 {
+ opp-hz = /bits/ 64 <345000000>;
+ required-opps = <&rpmhpd_opp_svs_l1>;
+ };
+
+ opp-460000000 {
+ opp-hz = /bits/ 64 <460000000>;
+ required-opps = <&rpmhpd_opp_nom>;
+ };
+ };
+
+ dsi_opp_table: dsi-opp-table {
+ compatible = "operating-points-v2";
+
+ opp-187500000 {
+ opp-hz = /bits/ 64 <187500000>;
+ required-opps = <&rpmhpd_opp_low_svs>;
+ };
+
+ opp-300000000 {
+ opp-hz = /bits/ 64 <300000000>;
+ required-opps = <&rpmhpd_opp_svs>;
+ };
+
+ opp-358000000 {
+ opp-hz = /bits/ 64 <358000000>;
+ required-opps = <&rpmhpd_opp_svs_l1>;
+ };
+ };
+
mdss: mdss@ae00000 {
compatible = "qcom,sc7180-mdss";
reg = <0 0x0ae00000 0 0x1000>;
@@ -1626,6 +1669,8 @@
<&dispcc DISP_CC_MDSS_VSYNC_CLK>;
assigned-clock-rates = <300000000>,
<19200000>;
+ operating-points-v2 = <&mdp_opp_table>;
+ power-domains = <&rpmhpd SC7180_CX>;
interrupt-parent = <&mdss>;
interrupts = <0 IRQ_TYPE_LEVEL_HIGH>;
@@ -1666,6 +1711,9 @@
"iface",
"bus";
+ operating-points-v2 = <&dsi_opp_table>;
+ power-domains = <&rpmhpd SC7180_CX>;
+
phys = <&dsi_phy>;
phy-names = "dsi";
Add the OPP tables for DSI and MDP based on the perf state/clk requirements, and add the power-domains property to specify the scalable power domain. Signed-off-by: Rajendra Nayak <rnayak@codeaurora.org> --- arch/arm64/boot/dts/qcom/sc7180.dtsi | 48 ++++++++++++++++++++++++++++++++++++ 1 file changed, 48 insertions(+)