diff mbox series

[RFC,7/8] thermal: of: Monitor thermal zone after enabling it

Message ID 20200407174926.23971-8-andrzej.p@collabora.com
State New
Headers show
Series Stop monitoring disabled devices | expand

Commit Message

Andrzej Pietrasiewicz April 7, 2020, 5:49 p.m. UTC 
thermal/of calls its own ->set_mode() method, so monitor thermal zone
afterwards. This is needed for the DISABLED->ENABLED transition.

Signed-off-by: Andrzej Pietrasiewicz <andrzej.p@collabora.com>
---
 drivers/thermal/of-thermal.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/thermal/of-thermal.c b/drivers/thermal/of-thermal.c
index b7621dfab17c..cf2c43ebcb78 100644
--- a/drivers/thermal/of-thermal.c
+++ b/drivers/thermal/of-thermal.c
@@ -523,8 +523,11 @@  thermal_zone_of_sensor_register(struct device *dev, int sensor_id, void *data,
 		if (sensor_specs.np == sensor_np && id == sensor_id) {
 			tzd = thermal_zone_of_add_sensor(child, sensor_np,
 							 data, ops);
-			if (!IS_ERR(tzd))
+			if (!IS_ERR(tzd)) {
 				tzd->ops->set_mode(tzd, THERMAL_DEVICE_ENABLED);
+				thermal_zone_device_update(tzd,
+						THERMAL_EVENT_UNSPECIFIED);
+			}
 
 			of_node_put(sensor_specs.np);
 			of_node_put(child);