@@ -30,6 +30,7 @@
#include <linux/platform_device.h>
#include <linux/reboot.h>
#include <linux/io.h>
+#include <linux/gpio.h>
#include <mach/hardware.h>
#include <asm/irq.h>
#include <asm/mach/arch.h>
@@ -288,8 +289,14 @@ static void n2100_power_off(void)
static void n2100_restart(enum reboot_mode mode, const char *cmd)
{
- gpio_line_set(N2100_HARDWARE_RESET, GPIO_LOW);
- gpio_line_config(N2100_HARDWARE_RESET, GPIO_OUT);
+ int ret;
+
+ ret = gpio_direction_output(N2100_HARDWARE_RESET, 0);
+ if (ret) {
+ pr_crit("could not drive reset GPIO low\n");
+ return;
+ }
+ /* Wait for reset to happen */
while (1)
;
}
@@ -311,6 +318,8 @@ static void power_button_poll(unsigned long dummy)
static void __init n2100_init_machine(void)
{
+ int ret;
+
platform_device_register(&iop3xx_i2c0_device);
platform_device_register(&n2100_flash_device);
platform_device_register(&n2100_serial_device);
@@ -326,6 +335,10 @@ static void __init n2100_init_machine(void)
power_button_poll_timer.function = power_button_poll;
power_button_poll_timer.expires = jiffies + (HZ / 10);
add_timer(&power_button_poll_timer);
+
+ ret = gpio_request(N2100_HARDWARE_RESET, "reset");
+ if (ret)
+ pr_err("could not request reset GPIO\n");
}
MACHINE_START(N2100, "Thecus N2100")
As the IOP GPIO driver supports gpiolib we can use the standard GPIO calls to issue a reset of the machine instead of using the custom gpio_line_set/config calls. Also request the GPIO when initializing the machine. Cc: Lennert Buytenhek <kernel@wantstofly.org> Cc: Dan Williams <dan.j.williams@intel.com> Cc: Mikael Pettersson <mikpe@it.uu.se> Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- arch/arm/mach-iop32x/n2100.c | 17 +++++++++++++++-- 1 file changed, 15 insertions(+), 2 deletions(-)