diff mbox series

ARM: dts: imx6qdl-gw53xx: allow boot firmware to set eth1 MAC

Message ID 1590695583-1327-1-git-send-email-tharvey@gateworks.com
State New
Headers show
Series ARM: dts: imx6qdl-gw53xx: allow boot firmware to set eth1 MAC | expand

Commit Message

Tim Harvey May 28, 2020, 7:53 p.m. UTC
The GW53xx has a PCIe based GbE as the 2nd ethernet device. The
boot firmware will populate the local-mac-address field of the
device aliased to ethernet1 thus adding the PCIe device to
dt allows boot firmware to set its MAC address.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
---
 arch/arm/boot/dts/imx6qdl-gw53xx.dtsi | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi b/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi
index 8942bec..6601d07 100644
--- a/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi
@@ -8,6 +8,7 @@ 
 / {
 	/* these are used by bootloader for disabling nodes */
 	aliases {
+		ethernet1 = &eth1;
 		led0 = &led0;
 		led1 = &led1;
 		led2 = &led2;
@@ -341,6 +342,23 @@ 
 	pinctrl-0 = <&pinctrl_pcie>;
 	reset-gpio = <&gpio1 29 GPIO_ACTIVE_LOW>;
 	status = "okay";
+
+	pcie@0,0,0 {
+		reg = <0x0000 0 0 0 0>;
+
+		pcie@1,0,0 {
+			reg = <0x0000 0 0 0 0>;
+
+			pcie@2,4,0 {
+				reg = <0x2000 0 0 0 0>;
+
+				eth1: pcie@4,0,0 {
+					reg = <0x0000 0 0 0 0>;
+					local-mac-address = [00 00 00 00 00 00];
+				};
+			};
+		};
+	};
 };
 
 &pwm2 {