@@ -2959,6 +2959,11 @@ static void ath10k_bss_assoc(struct ieee80211_hw *hw,
arvif->aid = bss_conf->aid;
ether_addr_copy(arvif->bssid, bss_conf->bssid);
+ ret = ath10k_wmi_pdev_set_param(ar,
+ ar->wmi.pdev_param->peer_stats_info_enable, 1);
+ if (ret)
+ ath10k_warn(ar, "failed to enable peer stats info: %d\n", ret);
+
ret = ath10k_wmi_vdev_up(ar, arvif->vdev_id, arvif->aid, arvif->bssid);
if (ret) {
ath10k_warn(ar, "failed to set vdev %d up: %d\n",
@@ -4269,6 +4269,7 @@ static struct wmi_pdev_param_map wmi_tlv_pdev_param_map = {
.arp_dstaddr = WMI_PDEV_PARAM_UNSUPPORTED,
.rfkill_config = WMI_TLV_PDEV_PARAM_HW_RFKILL_CONFIG,
.rfkill_enable = WMI_TLV_PDEV_PARAM_RFKILL_ENABLE,
+ .peer_stats_info_enable = WMI_TLV_PDEV_PARAM_PEER_STATS_INFO_ENABLE,
};
static struct wmi_peer_param_map wmi_tlv_peer_param_map = {
@@ -451,6 +451,7 @@ enum wmi_tlv_pdev_param {
WMI_TLV_PDEV_PARAM_VDEV_RATE_STATS_UPDATE_PERIOD,
WMI_TLV_PDEV_PARAM_TXPOWER_REASON_NONE,
WMI_TLV_PDEV_PARAM_TXPOWER_REASON_SAR,
+ WMI_TLV_PDEV_PARAM_PEER_STATS_INFO_ENABLE = 0x8b,
WMI_TLV_PDEV_PARAM_TXPOWER_REASON_MAX,
};
@@ -3798,6 +3798,7 @@ struct wmi_pdev_param_map {
u32 enable_btcoex;
u32 rfkill_config;
u32 rfkill_enable;
+ u32 peer_stats_info_enable;
};
#define WMI_PDEV_PARAM_UNSUPPORTED 0
For wmi tlv type, firmware disable peer stats info by default, after enable it, firmware will report WMI_TLV_PEER_STATS_INFO_EVENTID if ath10k send WMI_TLV_REQUEST_PEER_STATS_INFO_CMDID to firmware. Enable it will only set a flag in firmware, firmware will not report it without receive request WMI command. Tested with QCA6174 SDIO with firmware WLAN.RMH.4.4.1-00042. Signed-off-by: Wen Gong <wgong@codeaurora.org> --- drivers/net/wireless/ath/ath10k/mac.c | 5 +++++ drivers/net/wireless/ath/ath10k/wmi-tlv.c | 1 + drivers/net/wireless/ath/ath10k/wmi-tlv.h | 1 + drivers/net/wireless/ath/ath10k/wmi.h | 1 + 4 files changed, 8 insertions(+)