@@ -566,7 +566,7 @@ mt7530_mib_reset(struct dsa_switch *ds)
static void
mt7530_port_set_status(struct mt7530_priv *priv, int port, int enable)
{
- u32 mask = PMCR_TX_EN | PMCR_RX_EN;
+ u32 mask = PMCR_TX_EN | PMCR_RX_EN | PMCR_FORCE_LNK;
if (enable)
mt7530_set(priv, MT7530_PMCR_P(port), mask);
@@ -1512,7 +1512,7 @@ static void mt7530_phylink_mac_config(struct dsa_switch *ds, int port,
mcr_new &= ~(PMCR_FORCE_SPEED_1000 | PMCR_FORCE_SPEED_100 |
PMCR_FORCE_FDX | PMCR_TX_FC_EN | PMCR_RX_FC_EN);
mcr_new |= PMCR_IFG_XMIT(1) | PMCR_MAC_MODE | PMCR_BACKOFF_EN |
- PMCR_BACKPR_EN | PMCR_FORCE_MODE | PMCR_FORCE_LNK;
+ PMCR_BACKPR_EN | PMCR_FORCE_MODE;
/* Are we connected to external phy */
if (port == 5 && dsa_is_user_port(ds, 5))
Andrew reported: After a number of network port link up/down changes, sometimes the switch port gets stuck in a state where it thinks it is still transmitting packets but the cpu port is not actually transmitting anymore. In this state you will see a message on the console "mtk_soc_eth 1e100000.ethernet eth0: transmit timed out" and the Tx counter in ifconfig will be incrementing on virtual port, but not incrementing on cpu port. The issue is that MAC TX/RX status has no impact on the link status or queue manager of the switch. So the queue manager just queues up packets of a disabled port and sends out pause frames when the queue is full. Change the LINK bit to reflect the link status. Fixes: b8f126a8d543 ("net-next: dsa: add dsa support for Mediatek MT7530 switch") Reported-by: Andrew Smith <andrew.smith@digi.com> Signed-off-by: René van Dorst <opensource@vdorst.com> --- drivers/net/dsa/mt7530.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)