@@ -194,6 +194,44 @@
#define STFSM_FLASH_SAFE_FREQ 10000000UL /* 10 MHz */
+/* Flash Commands */
+#define FLASH_CMD_WREN 0x06
+#define FLASH_CMD_WRDI 0x04
+#define FLASH_CMD_RDID 0x9f
+#define FLASH_CMD_RDSR 0x05
+#define FLASH_CMD_RDSR2 0x35
+#define FLASH_CMD_WRSR 0x01
+#define FLASH_CMD_SE_4K 0x20
+#define FLASH_CMD_SE_32K 0x52
+#define FLASH_CMD_SE 0xd8
+#define FLASH_CMD_CHIPERASE 0xc7
+#define FLASH_CMD_WRVCR 0x81
+#define FLASH_CMD_RDVCR 0x85
+
+#define FLASH_CMD_READ 0x03 /* READ */
+#define FLASH_CMD_READ_FAST 0x0b /* FAST READ */
+#define FLASH_CMD_READ_1_1_2 0x3b /* DUAL OUTPUT READ */
+#define FLASH_CMD_READ_1_2_2 0xbb /* DUAL I/O READ */
+#define FLASH_CMD_READ_1_1_4 0x6b /* QUAD OUTPUT READ */
+#define FLASH_CMD_READ_1_4_4 0xeb /* QUAD I/O READ */
+
+#define FLASH_CMD_WRITE 0x02 /* PAGE PROGRAM */
+#define FLASH_CMD_WRITE_1_1_2 0xa2 /* DUAL INPUT PROGRAM */
+#define FLASH_CMD_WRITE_1_2_2 0xd2 /* DUAL INPUT EXT PROGRAM */
+#define FLASH_CMD_WRITE_1_1_4 0x32 /* QUAD INPUT PROGRAM */
+#define FLASH_CMD_WRITE_1_4_4 0x12 /* QUAD INPUT EXT PROGRAM */
+
+#define FLASH_CMD_EN4B_ADDR 0xb7 /* Enter 4-byte address mode */
+#define FLASH_CMD_EX4B_ADDR 0xe9 /* Exit 4-byte address mode */
+
+/* READ commands with 32-bit addressing (N25Q256 and S25FLxxxS) */
+#define FLASH_CMD_READ4 0x13
+#define FLASH_CMD_READ4_FAST 0x0c
+#define FLASH_CMD_READ4_1_1_2 0x3c
+#define FLASH_CMD_READ4_1_2_2 0xbc
+#define FLASH_CMD_READ4_1_1_4 0x6c
+#define FLASH_CMD_READ4_1_4_4 0xec
+
struct stfsm {
struct device *dev;
void __iomem *base;
Flash chip commands are issued using a set of predefined opcodes. These are mostly the same for all flash devices, but do differ on occasion. This patch supplies the majority of the key ones which will be used in this driver. Signed-off-by: Lee Jones <lee.jones@linaro.org> --- drivers/mtd/devices/st_spi_fsm.c | 38 ++++++++++++++++++++++++++++++++++++++ 1 file changed, 38 insertions(+)