new file mode 100644
@@ -0,0 +1,80 @@
+# SPDX-License-Identifier: (GPL-2.0+ OR BSD-2-Clause)
+# Copyright (C) 2020 Texas Instruments Incorporated
+%YAML 1.2
+---
+$id: "http://devicetree.org/schemas/net/ti,dp83822.yaml#"
+$schema: "http://devicetree.org/meta-schemas/core.yaml#"
+
+title: TI DP83822 ethernet PHY
+
+maintainers:
+ - Dan Murphy <dmurphy@ti.com>
+
+description: |
+ The DP83822 is a low-power, single-port, 10/100 Mbps Ethernet PHY. It
+ provides all of the physical layer functions needed to transmit and receive
+ data over standard, twisted-pair cables or to connect to an external,
+ fiber-optic transceiver. Additionally, the DP83822 provides flexibility to
+ connect to a MAC through a standard MII, RMII, or RGMII interface
+
+ Specifications about the Ethernet PHY can be found at:
+ http://www.ti.com/lit/ds/symlink/dp83822i.pdf
+
+allOf:
+ - $ref: "ethernet-phy.yaml#"
+
+properties:
+ reg:
+ maxItems: 1
+
+ ti,link-loss-low:
+ type: boolean
+ description: |
+ DP83822 PHY in Fiber mode only.
+ Sets the DP83822 to detect a link drop condition when the signal goes
+ high. If not set then link drop will occur when the signal goes low.
+ This property is only applicable if the fiber mode support is strapped
+ to on.
+
+ ti,fiber-mode:
+ type: boolean
+ description: |
+ DP83822 PHY only.
+ If present the DP83822 PHY is configured to operate in fiber mode
+ Fiber mode support can also be strapped. If the strap pin is not set
+ correctly or not set at all then this boolean can be used to enable it.
+ If the fiber mode is not strapped then signal detection for the PHY
+ is disabled.
+ In fiber mode, auto-negotiation is disabled and the PHY can only work in
+ 100base-fx (full and half duplex) modes.
+
+ rx-internal-delay-ps:
+ description: |
+ DP83822 PHY only.
+ Setting this property to a non-zero number sets the RX internal delay
+ for the PHY. The internal delay for the PHY is fixed to 3.5ns relative
+ to receive data.
+
+ tx-internal-delay-ps:
+ description: |
+ DP83822 PHY only.
+ Setting this property to a non-zero number sets the TX internal delay
+ for the PHY. The internal delay for the PHY is fixed to 3.5ns relative
+ to transmit data.
+
+required:
+ - reg
+
+examples:
+ - |
+ mdio0 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ ethphy0: ethernet-phy@0 {
+ reg = <0>;
+ rx-internal-delay-ps = <1>;
+ tx-internal-delay-ps = <1>;
+ };
+ };
+
+...
Add a dt binding for the TI dp83822 ethernet phy device. CC: Rob Herring <robh+dt@kernel.org> Signed-off-by: Dan Murphy <dmurphy@ti.com> --- .../devicetree/bindings/net/ti,dp83822.yaml | 80 +++++++++++++++++++ 1 file changed, 80 insertions(+) create mode 100644 Documentation/devicetree/bindings/net/ti,dp83822.yaml -- 2.27.0