@@ -24,6 +24,8 @@
#define MC_BOOT_ENV_VAR "mcinitcmd"
+#ifndef CONFIG_DM_ETH
+
#if defined(CONFIG_FSL_MC_ENET) && !defined(CONFIG_SPL_BUILD)
/* - In LS2080A there are only 16 SERDES lanes, spread across 2 SERDES banks.
* Bank 1 -> Lanes A, B, C, D, E, F, G, H
@@ -889,9 +891,11 @@ void ls2080a_handle_phy_interface_xsgmii(int i)
}
}
#endif
+#endif // !CONFIG_DM_ETH
int board_eth_init(bd_t *bis)
{
+#ifndef CONFIG_DM_ETH
int error;
#if defined(CONFIG_FSL_MC_ENET) && !defined(CONFIG_SPL_BUILD)
struct ccsr_gur __iomem *gur = (void *)CONFIG_SYS_FSL_GUTS_ADDR;
@@ -970,8 +974,13 @@ int board_eth_init(bd_t *bis)
sgmii_configure_repeater(2);
}
#endif
- error = pci_eth_init(bis);
- return error;
+#endif // !CONFIG_DM_ETH
+
+#ifdef CONFIG_DM_ETH
+ return 0;
+#else
+ return pci_eth_init(bis);
+#endif
}
#if defined(CONFIG_RESET_PHY_R)
@@ -251,6 +251,10 @@ int board_init(void)
ppa_init();
#endif
+#if !defined(CONFIG_SYS_EARLY_PCI_INIT) && defined(CONFIG_DM_ETH)
+ pci_init();
+#endif
+
return 0;
}
In case CONFIG_DM_ETH is enabled, no hardcoding is necessary for DPAA2 Ethernet devices. Compile out any unnecessary setup when CONFIG_DM_ETH is activated. Also, force the PCI devices to be enumerated at probe time. Signed-off-by: Ioana Ciornei <ioana.ciornei at nxp.com> --- board/freescale/ls2080aqds/eth.c | 13 +++++++++++-- board/freescale/ls2080aqds/ls2080aqds.c | 4 ++++ 2 files changed, 15 insertions(+), 2 deletions(-)