@@ -107,6 +107,8 @@
#define EMAC_RX_CTL0_RX_EN BIT(31)
#define EMAC_RX_CTL1 0x28
#define EMAC_RX_CTL1_RX_MD BIT(1)
+#define EMAC_RX_CTL1_RX_RUNT_FRM BIT(2)
+#define EMAC_RX_CTL1_RX_ERR_FRM BIT(3)
#define EMAC_RX_CTL1_RX_DMA_EN BIT(30)
#define EMAC_RX_CTL1_RX_DMA_START BIT(31)
#define EMAC_RX_DMA_DESC 0x34
@@ -125,6 +127,8 @@
#define EMAC_DESC_FIRST_DESC BIT(29)
#define EMAC_DESC_CHAIN_SECOND BIT(24)
+#define EMAC_DESC_RX_ERROR_MASK 0x400068db
+
DECLARE_GLOBAL_DATA_PTR;
enum emac_variant {
@@ -485,7 +489,8 @@ static int sun8i_emac_eth_start(struct udevice *dev)
sun8i_adjust_link(priv, priv->phydev);
/* Start RX/TX DMA */
- setbits_le32(priv->mac_reg + EMAC_RX_CTL1, EMAC_RX_CTL1_RX_DMA_EN);
+ setbits_le32(priv->mac_reg + EMAC_RX_CTL1, EMAC_RX_CTL1_RX_DMA_EN |
+ EMAC_RX_CTL1_RX_ERR_FRM | EMAC_RX_CTL1_RX_RUNT_FRM);
setbits_le32(priv->mac_reg + EMAC_TX_CTL1, EMAC_TX_CTL1_TX_DMA_EN);
/* Enable RX/TX */
@@ -565,10 +570,8 @@ static int sun8i_emac_eth_recv(struct udevice *dev, int flags, uchar **packetp)
struct emac_eth_dev *priv = dev_get_priv(dev);
u32 status, desc_num = priv->rx_currdescnum;
struct emac_dma_desc *desc_p = &priv->rx_chain[desc_num];
- int length = -EAGAIN;
- int good_packet = 1;
- ulong data_start = (uintptr_t)desc_p->buf_addr;
- ulong data_end;
+ uintptr_t data_start = (uintptr_t)desc_p->buf_addr;
+ int length;
/* Invalidate entire buffer descriptor */
cache_inv_descriptor(desc_p);
@@ -576,30 +579,31 @@ static int sun8i_emac_eth_recv(struct udevice *dev, int flags, uchar **packetp)
status = desc_p->status;
/* Check for DMA own bit */
- if (!(status & EMAC_DESC_OWN_DMA)) {
- length = (desc_p->status >> 16) & 0x3FFF;
+ if (status & EMAC_DESC_OWN_DMA)
+ return -EAGAIN;
- if (length < 0x40) {
- good_packet = 0;
- debug("RX: Bad Packet (runt)\n");
- }
+ length = (status >> 16) & 0x3fff;
- data_end = data_start + length;
- /* Invalidate received data */
- invalidate_dcache_range(rounddown(data_start,
- ARCH_DMA_MINALIGN),
- roundup(data_end,
- ARCH_DMA_MINALIGN));
- if (good_packet) {
- if (length > CONFIG_ETH_RXSIZE) {
- printf("Received packet is too big (len=%d)\n",
- length);
- return -EMSGSIZE;
- }
- *packetp = (uchar *)(ulong)desc_p->buf_addr;
- return length;
- }
+ /* make sure we read from DRAM, not our cache */
+ invalidate_dcache_range(data_start,
+ data_start + roundup(length, ARCH_DMA_MINALIGN));
+
+ if (status & EMAC_DESC_RX_ERROR_MASK) {
+ debug("RX: packet error: 0x%x\n",
+ status & EMAC_DESC_RX_ERROR_MASK);
+ return 0;
}
+ if (length < 0x40) {
+ debug("RX: Bad Packet (runt)\n");
+ return 0;
+ }
+
+ if (length > CONFIG_ETH_RXSIZE) {
+ debug("RX: Too large packet (%d bytes)\n", length);
+ return 0;
+ }
+
+ *packetp = (uchar *)(ulong)desc_p->buf_addr;
return length;
}
The error handling in recv() is somewhat broken, for instance good_packet isn't really used, and it's hardly readable. Also we try to check for short or too big packets, but those are actually filtered out by the hardware. Simplify the whole routine and improve the error handling: - Bail out early if the current RX descriptor is not ready. - Enable propagation of runt, huge and broken packets. - Check for runt and huge packets, and return 0 to indicate this. This will force the framework to call free_pkt for cleanup. - Avoid aligning the packet buffer for invalidation again. Signed-off-by: Andre Przywara <andre.przywara at arm.com> --- drivers/net/sun8i_emac.c | 56 +++++++++++++++++++++------------------- 1 file changed, 30 insertions(+), 26 deletions(-)